Recommended Engine Block Heater For 2001 Dodge Ram 5.9L Diesel

Question

Question:

I am looking to purchase a block heater for my dodge 2001 Diesel engine, that does not involve ping the oil pan for installation. Does your item # KH30115 work for my truck, and what fluid has to be drained for installation? Thanks,

asked by: Mike G

1

Helpful Expert Reply:

The Kat's Heaters Custom Diesel Engine Block Heater - Frost Plug - 120V - 750 Watts - 3/4" NPT, # KH30115, is a confirmed fit for your 2001 Dodge Ram 5.9L Diesel. This frost plug heater replaces the frost plug in your engine block and submerges in the coolant to keep engine fluids from thickening. It will result in easier start-ups, less wear and tear on your vehicle in cold weather, and it will help your truck cab to heat faster. This does require draining the cooling system only for installation.

Another option for you is Kat's Heaters Thermostatically Controlled Circulating Tank Heater - 120V - 1,500 Watts, # KH13150. This heater installs inline with the heater hoses for a fairly simple installation and is also a confirmed fit for your vehicle. This will also require draining your cooling system only to install.

These heaters are not to be used with 100% coolant. I suggest using a 50/50 mix of coolant and water for proper operation. Make sure to route cord away from extreme heat or moving mechanical parts.

expert reply by: Jason S

1

Answer 1

I really wish we had the chance to install the Kat's heater #KH13150 so we could provide an install video or pictures but the best is the following written instructions: To install the heater you will first need to drain the cooling system. Then…

view full answer...

Answer 2

For starters, the Kat's Heaters Thermostatically Controlled Circulating Tank Heater part #KH13150 would most likely not bring the engine up to operating temperature as that is not its intended purpose. The purpose of the unit is to preheat the…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 6

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 7

If you take a look at the linked diagram you can see the minimum recommended clearance distances between truck and trailer for 5th wheel towing. It is recommended to have at least 5-inches from the top of the bed rails to the bottom of the trailer…

view full answer...