What is the inner Diameter of the Cap Included with Replacement Black Handle # HDKB-BLK

Question

Question:

What is the size of the metal crank on which this fits i.e. what is the inside diameter of the cap?

asked by: Robert M

0

Expert Reply:

I went out to the warehouse and measured the inner diameter of the cap included with Replacement Black Handle # HDKB-BLK. It is approximately 1/2 inch.

expert reply by: Michael H

0

Answer 1

I do have an option for you but the Curt Trailer Hitch Receiver part #C15800 is designed for passenger vehicles like the Ram 3500, Chevrolet Silverado 3500, and GMC Sierra 3500 so it will not fit your 2009 Volvo D13. However, what you can use is the…

view full answer...

Answer 2

If you have a 3-wire system on your vehicle (separate stop and turn) and your LED light is 2-wire (combined stop and turn), then you need a 3-to-2 converter. I recommend the Hopkins Tail Light Converter, part #HM48847. It's LED compatible and…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 9

The trailer brakes work on a separate circuit than the lights. You have a couple of options to control the electric brakes on the trailer. One option is to use an air over electric brake control, #HA100400C. This unit connects to the air brakes on…

view full answer...

Answer 10

You do have the option to utilize the air brakes on your 2023 Freightliner Cascadia to control electric trailer brakes using the Hayes Air Actuated Trailer Brake Controller, part #HA100400C. However, we mostly recommend just using an electric brake…

view full answer...

Answer 11

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 12

The brake controller port on a 2021 Ford F-150 (if equipped) will be located behind the coin tray in the center console. This will be accessed by removing the panel under the steering wheel. I have attached a video which shows this below. For a brake…

view full answer...

What is the inner Diameter of the Cap Included with Replacement Black Handle # HDKB-BLK

Product Page this Question was Asked From

Continue Researching