Brake Controller Install and Recommendation for 2006 Dodge Ram 1500 with 4-Way
Question:
If I have a 2006 Dodge Ram 1500 that is already wired with a 4 pin flat, do I need to purchase and install item ETBC7 to use the TeKonsha Brake Controller - 39510?
asked by: Nic B
Expert Reply:
On a 2006 Dodge Ram that came with a factory installed 4-Way trailer connector the brake (blue) wire does not run all the way back to the back of the truck; it stops at the connector that is located under the driver's side wheel well. In order to finalize the installation you must splice into this wire and continue it back to the plug.
The 12 volt circuit wire is also not present at the back so what I recommend is to use about 20 feet of wire # 10-2-1 (sold by the foot) to complete the installation. You will also need a 40 amp circuit breaker, # PK54540, for the 12 volt circuit.
For a 7-way you then would want the part # 37185. The wire will get ran to the blue wire of this.
For a brake controller I would recommend the Prodigy P2 Brake Controller part # 90885. This is our best selling brake controller because of how well it works and how easy it is to setup. This is a proportional brake controller that senses the amount of braking the tow vehicle is applying and applies a proportionate amount to the trailer brakes. The # 39510 you mentioned would work as well though.
The correct harness you would need then would be the part # 3020-P which will allow you to plug the controller right into your truck.
Products Referenced in This Question
Deka Jacketed 2 Wire, 10 Gauge, Brake Wire - per Foot
- Wiring
- Wire
- Jacketed Wire
- 2 Wire
- 10 Gauge
- Deka
more information >
Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers - Dodge
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Vehicle Specific
- Tekonsha
more information >
Tekonsha Voyager Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Manual Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- Indicator Lights
- Up to 90 Degrees
- Tekonsha
more information >
Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LED Display
- Up to 360 Degrees
- Tekonsha
more information >
Pollak Circuit Breaker - Cycling/Automatic Reset - 40 Amp - Straight Mount Bracket
- Accessories and Parts
- Wiring
- Circuit Breaker
- 40 Amp
- Pollak
more information >
Product Page this Question was Asked From
Adapter 4-Pole to 7-Pole and 4-Pole
- Trailer Wiring
- Wiring Adapters
- Multi-Function Adapter
- 4 Flat
- Plug and Lead
- 4 Flat
- 7 Round - Blade
- Hopkins
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Article: Brake Controller Installation on a Ford Full-Size Van
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Measure for Trailer Hitch Drop
- Q&A: How To Connect 4-Way Flat Vehicle Connector To 7-Way on Trailer
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: My Vehicle has a 4-Pin Trailer Plug, but Trailer has 7-Pin Trailer Plug
- Q&A: Parts Needed to Install 7-Way Trailer Connector on 2021 Honda Odyssey
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Installing A Reese Brakeman Controller In A 202 Ford E250 With Factory 4-Flat
- Q&A: Trailer Hitch for a Lance Travel Trailer