Weight Distribution System Recommendation for Towing 7,000 lb Trailer
Question:
Hello, I am looking for Wt Dist hitch recommendations. I have a 24 Ft TT with 7K TGW, pulling behind a Toyota Tundra. What do you recommend for a brand with that setup. I am looking for one with good sway control and one that is fairly quiet too reading some the complaints online.
asked by: Wayne S
Expert Reply:
The best way to pick out a weight distribution system is to base it off of the loaded tongue weight of the setup when it is loaded and ready to tow. This figure also includes the weight of any cargo behind the rear axle of the tow vehicle. I attached a help article on determining tongue weight for you to check out as well. You will want the loaded tongue weight of your setup to fall right in the middle of the tongue weight range of the system you use.
If your trailer is going to weigh 7k lbs your tongue weight is most likely going to be between 700 and 1,050 lbs. For a WD system with sway control for that I would recommend the Strait Line system part # RP66084 which has a tongue weight range of 600-1,200 lbs and features the only sway control that tries to stop sway before it starts. Every system is going to make a bit of noise just due to the nature of how they work, but this one won't be too bad under normal circumstances.
For a 2 inch ball you would want part # A-90 and for a 2-5/16 inch ball # 19286.
Products Referenced in This Question
2-5/16" Hitch Ball - 1-1/4" Diameter x 2-3/4" Long Shank - Chrome - 12,000 lbs
- Trailer Hitch Ball
- Trailer Hitch Ball
- Standard Ball
- Chrome-Plated Steel
- 2-5/16 Inch Diameter Ball
- 2-3/4 Inch Shank Length
- 1-1/4 Inch Diameter Shank
- 12000 lbs GTW
- Class IV
- Class V
- Draw-Tite
more information >
2" Hitch Ball - 1-1/4" Diameter x 2-5/8" Long Shank - Chrome - 10,000
- Trailer Hitch Ball
- Trailer Hitch Ball
- Standard Ball
- Chrome-Plated Steel
- 2 Inch Diameter Ball
- 2-5/8 Inch Shank Length
- 1-1/4 Inch Diameter Shank
- 10000 lbs GTW
- Class IV
- Class V
- CURT
more information >
Product Page this Question was Asked From
Strait-Line Weight Distribution System w/ Sway Control - Trunnion Bar - 12,000 lbs GTW, 1,200 lbs TW
- Weight Distribution Hitch
- WD With Sway Control
- Some Sway
- Includes Shank
- Electric Brake Compatible
- Fits 2 Inch Hitch
- Allows Backing Up
- 1000 lbs
- 1100 lbs
- 700 lbs
- 800 lbs
- 900 lbs
- Reese
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Determining Trailer Tongue Weight
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Q&A: Recommended TorkLift Hitch and Extension for a 2024 Chevy Silverado 3500
- Article: How to Measure for Trailer Hitch Drop
- Article: 5 Tips to Confidently Choose Your Weight Distribution Hitch
- Q&A: Can the TorkLift Everest Weight Distribution System Be Used w/ a SuperTruss Extension?
- Q&A: Is there a Longer Weight Distribution Shank for a B&W Continuum?
- Q&A: What Does Underslung Coupler Look Like for Picking Out B and W Continuum Weight Distribution
- Q&A: Recommended Weight Distribution System for a 6,800 lbs 2019 Lance 2465 Travel Trailer
- Article: Tire TLC: How & When to Check Your RV/Trailer Tire Pressure
- Q&A: Comparing the Equal-i-zer Hitch Vs The Reese Wieght Distribution Hitch With Dual Cam Sway Control
- Q&A: Can Strait Line Weight Distribution be Used with Feather Lite Trailer