7-Way, Vehicle End, Trailer Connector Wiring Diagram

Question

Question:

I would like a wiring diagram for a 7 pole trailer connecter socket vehicle end for a 95 chevy van G20 thank you

asked by: Ray

0

Expert Reply:

See the picture to the right for a wiring diagram of seven-way vehicle end trailer connector. If you click on it you can enlarge it.

I have also included a trailer wiring FAQ page for you to check out.

expert reply by: Jameson C

0

click to enlarge

Mike

5/21/2020

I just purchased your Kurt hitch and a wiring set up I need to know color code for Chevy Silverado 2004 25 HD trailer package not the kit that I bought from you. There is a light blue with a connector on it not sure what that goes to then there’s a dark blue I believe that goes to the brakes is it black or red in heavier gauge then light green dark green brown and yellow can you help please

Reply

Chris R.

5/25/2020

I'm honestly not sure which factory wire colors carry which function on your Silverado. The best way to determine this is to actually test them for power using a circuit tester - you'll simply probe the wires in question while you activate each function in the cab (turn signals, running lights, etc) to see which wire carries power for each one. This will be the most accurate method for wiring up the truck.

Reply

Answer 1

Traditionally, trailer manufacturers did not use electric brakes on boat trailers because the brake magnet wiring and trailer wiring did not always have the best insulation or water protection. These days, more and more manufacturers are using…

view full answer...

Answer 2

When hardwiring a 7-Way to your 2005 Chevrolet Silverado, like part #PK12-707E, you will want to connect the following functions to the following pin locations: 1 o'clock - 12V Power 3 o'clock - Right Turn/Stop 5 o'clock -…

view full answer...

Answer 3

I have attached a photo for you below which shows how both a vehicle side and trailer side trailer connector is typically wired. I say typically because this is not always exact and so long as the trailer and vehicle side both match it will not…

view full answer...

Answer 4

On Dexter 12" Nev-R-Adjust Electric Brake Assembly #23-458 the shoe pad thickness is 3/16 of an inch. Dexter says that you should replace the shoes if the material gets down to 1/16 of an inch thick or less.

view full answer...

Answer 5

When wiring a trailer connector, it is best to wire by function, as wire colors can vary. We have an excellent wiring diagram on our website, I will provide you a link so you can look at it. If you are looking at the inside of the trailer connector…

view full answer...

Answer 6

Yes, we have diagrams for nearly every type of trailer wiring connector available. Check out the link I attached to see them all. Most likely you have a 7-way on your 2008 Chevy Silverado so I attached a picture of a diagram of a 7-way.

view full answer...

Answer 7

The problem that you are going to run into no matter what 7-Way you want to put on your trailer is that the color of the wires used is not standardized. Trailer manufacturers or people who rewire their trailers at any point can use any color they…

view full answer...

Answer 8

Yes, for your Dexter 10k axles you can use the 10k brake assemblies part #AKEBRK-10R and #AKEBRK-10L that you mentioned. These were designed for your Dexter 10k axles and the slight narrower width would not be an issue at all.

view full answer...

Answer 9

To see a couple diagrams that show how the 6-way to 7-way adapter part #47435 is wired up check out the pictures I attached. The 6-way of this adapter has the center pin as the 12 volt circuit. That is the usual circuit that gets moved around on…

view full answer...

Answer 10

That number is probably 4 mm which that amount is acceptable. Normally trailer brake thicknesses are done by inch though. 3/16 of an inch is what they are new and then they should get replaced at 1/16 of an inch.

view full answer...

Answer 11

I looked up the trailer connector wiring diagram for a 2007 Ford F-250 which should be the same as a Ford F-350 and found the 7-way trailer connector to contain the following wires: Orange = 12 Volt Power White = Ground Black/Green = Reverse Blue =…

view full answer...

Answer 12

According to my research the following wires for the 7-Way on your 2019 Chevy Silverado 2500 should carry the following functions: Green OR White/Green - Reverse White - Ground Blue - Brake Controller Green OR Green/Purple - Right Turn/Stop Red/Black…

view full answer...

7-Way, Vehicle End, Trailer Connector Wiring Diagram

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching