Do You Measure Straight Up and Down to Choose RV/Camper Steps

Question

Question:

How do I measure the height of the steps I need please do I measure straight down from the door or do I have to use a angle finder thanks

asked by: Bill

0

Expert Reply:

You can measure straight down from the bottom of the door to the ground to choose stairs. A popular option is scissor steps. I have included a link to the options for you. We have 2 to 6 step models available with different heights.

expert reply by: Michael H

0

Answer 1

The Hitch Stair with 2 Steps #RHS2 that you referenced weighs 19 lbs and has a weight capacity of 250 lbs. I attached a review video for this for you to check out as well.

view full answer...

Answer 2

If you just need to replace the converter, the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers part #PD4635V will be a direct upgrade for the Magnetek Converter Series 6300 Model 6332 that you have now. The built-in Charge…

view full answer...

Answer 3

If you are just looking for a new converter, the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers part #PD4635V will be a direct upgrade for the Magnetek Converter Series 6300 Model 6332 that you have now.

view full answer...

Answer 4

Hey Al, this is a great question but since you have free-backing plates now you would never need to mess with the manual lock out of your Atwood coupler.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 8

Hey Roy, The only U-bolt kit we currently only offer for 1-1/2" square axles is part #CE23102, which only has a 3-3/8" length so it likely wouldn't be the best option for you. Instead you'll want to order the 1-1/2" Square…

view full answer...

Answer 9

Are you basically asking how much length would this coupler add to the tongue of your trailer?

view full answer...

Answer 10

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 11

The connection on the Seaflo Submersible Utility Pump #SE54FR is designed to fit a hose with an inner diameter of 13 mm.

view full answer...

Answer 12

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Do You Measure Straight Up and Down to Choose RV/Camper Steps

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching