Which Hayes 10k Caliper is Correct Replacement for Driver Side of Trailer

Question

Question:

I need the drivers side, do you consider that lh or rh?

asked by: Matt F

0

Expert Reply:

The driver side caliper would be the left hand side so you would need the part # BP18-050 instead of the part # BP18-060 that you referenced.

expert reply by: Jameson C

0

Answer 1

It looks like you are looking for disc brakes based on the AL-KO/Hayes Disc Brake Caliper -10,000 lbs and 12,000 lbs - Driver's-Side #BP18-050 you asked from. For the disc brake compatible electric over hydraulic actuator I recommend the…

view full answer...

Answer 2

Yes we do, for your AL-KO 10k axles the correct caliper for the left hand side of your trailer would be the #BP18-050. For the right hand side the part number is #BP18-060. For replacement pads you would want the Disc Brake Pads part #BP04-400.

view full answer...

Answer 3

The leaning that is occurring in your 2016 Stryker could be a number of issues, and you asked a good question about your leaf springs. Since these do flatten out (essentially elongating) over time, that could very well be the issue, but there is no…

view full answer...

Answer 4

The KH97202 caliper you have pictured can actually be the left (driver) side or the right (passenger) side. So it wasn't necessarily installed backwards and I found a couple pictures showing that they used to put that casting number on both…

view full answer...

Answer 5

Most likely what you'll want is a wheel and tire combo like the part #AM3S130 which is a tire size of ST175/80-13 mounted on a wheel with a 4 on 4 inch bolt pattern. But we do need to verify your bolt pattern is 4 on 4 inch. Could I get you to…

view full answer...

Answer 6

We do not offer wishbone wiring that has a ground wire going down both sides. You really don't need it because the ground wire is for the plug itself not the lights and you want the ground close to the plug. I recommend using the 4-Way Wishbone…

view full answer...

Answer 7

Sure thing; the JRV9000R is a double-din stereo so you can replace it with another double din, and for that I recommend the Jensen RV Stereo w/ DVD Player #JWM45. The #JWM45 is a 48 watt stereo that also has the DVD functionality and will fit in the…

view full answer...

Answer 8

To replace your JVR9000 I recommend the Jensen RV Stereo - Double DIN - AUX/USB, Bluetooth #JWM40. It has slightly different dimensions that can be easily fixed using a dash plate. This won't have a monitor to watch your video feeds from so…

view full answer...

Answer 9

The Curt #C56196 2 to 3 wire taillight converter is exactly what you'll need to split out the turn signal function from the brake lamp circuit. However, keep in mind that the #C56196 is NOT compatible with LED lamps, unfortunately we don't…

view full answer...

Answer 10

According to your owners manual, you can absolutely flat tow your specific model. It is not recommended to tow this vehicle over 65 mph. You will also need to start the engine and allow it to run for five minutes at the beginning of each day and…

view full answer...

Answer 11

I have a solution for you, however, the jack that you referenced will not fit a 5 inch trailer tongue. The Fulton Bolt-Thru Swivel Marine Jack, #FXP15, will fit 3 inch x 5 inch trailer tongue and has a lift capacity of 1,500 lbs. This Fulton jack is…

view full answer...

Answer 12

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Which Hayes 10k Caliper is Correct Replacement for Driver Side of Trailer

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching