Length of Super Springs SumoSprings for 2015 Jeep Wrangler Unlimited

Question

Question:

HI. I have a 2015 Jeep Unlimited. I pull a popup camper and it sags me pretty good in the back. These appear to be perfect to help me out. I dont want bags in the springs. WHats the length of these? I want them making contact when the trailer is attached other wise they are no good for me. Hopefully they are quite a bit longer than the factory bump stops. Once I know the length I can measure with the trailer attached and see if they will work. Thanks,

asked by: Matt T

0

Expert Reply:

The SumoSprings Solo Custom Helper Springs # SSR-405-47 are a great choice for your 2015 Jeep Wrangler Unlimited if it has a 2 inch lift. I spoke with my contact at SuperSprings and he confirmed that this spring in this system measures 4-1/2 inches.

If your Wrangler Unlimited has a stock suspension height, you will want to use the SumoSpring Solo Custom Helper Springs # SSR-401-47. These springs are slightly shorter than the springs referenced above, measuring approximately 3-3/4 inches.

The installation instructions for both of these sets of springs are attached for you.

expert reply by: Victoria B

0

click to enlarge

Answer 1

We have front suspension enhancement that does fit your 2016 Jeep Wrangler and is intended for off-road applications like I can see in your picture, but we don't have any air bag style kits. Instead we have jounce bumper style kits like the…

view full answer...

Answer 2

The SumoSprings Solo Custom Helper Springs for Jeep - Front Axle - Off-Road - 2" Lift Spacers #SSF-403-54 has a height of 3.800 inches. The #SSR-401-47 has this same height with a 1000 lb capacity , where the #SSR-405-47 has a height of 4.5…

view full answer...

Answer 3

The SumoSprings Solo Custom Helper Springs item #SSR-405-47 that fit a 2012 - 2023 Jeep Wrangler should have a 1/2" to an 1" of space between them and your axle.

view full answer...

Answer 4

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 7

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 8

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Answer 9

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 10

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 11

The best option we offer for your dump trailer is the Erickson Mesh Tarp and Truck Bed Cover part #EM57059 which measures 12' wide x 16' long. It's not the exact dimensions you wanted but it will still cover most of the area you need it…

view full answer...

Answer 12

To tow your trailer that uses an RV style 7-way blade style connector with your semi that has a 7-pin connector, you need to construct an adapter that will also combine the brake signal into the right and left directional signal pins. This can be…

view full answer...

Length of Super Springs SumoSprings for 2015 Jeep Wrangler Unlimited

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching