Trailer Hitch Fit for 1997 Suzuki Sidekick Sport

Question

Question:

Will a hitch for a suzuki xl7 fit a 1997 suzuki sidekick jlx sport 4 door?

asked by: Josh

0

Expert Reply:

The Curt hitch # C11024 you were looking at is the only hitch confirmed to fit for your 1997 Suzuki Sidekick JLX Sport 4-door.

The trailer hitch for the Suzuki XL7 will not fit the Sidekick Sport.

I have linked the Curt hitch to this page for your purchasing convenience.

expert reply by: Jackie C

0

Answer 1

I contacted our representative at Hidden Hitch about the Draw-Tite Trailer Hitch, part #24677. The representative at Draw-Tite informed me that the thickness of the tubing for part #24677 is 3/16 inches. The arms of the hitch that connect to the…

view full answer...

Answer 2

On a 2001 Chevy Tracker the connection point for the part #C55372 is located in the inside of the driver's side tire jack compartment. The Tracker that you can see in the install instructions link that I attached is also a convertible.

view full answer...

Answer 3

As the instructions for the Roadmaster #1012-1 base plates aren't very detailed, I've contacted my contact in the Engineering department at Roadmaster who was able to find a photo for you. The photo I've provided shows the front…

view full answer...

Answer 4

A Class I hitch like Curt part #11128 which fits your 1990 Suzuki Sidekick must be used with only Class I-compatible accessories. This includes items like bike racks and hitch adapters. There are some 1-1/4-inch hitch adapters that will not work in a…

view full answer...

Answer 5

Since your 1996 Geo Tracker 4X4 does not have the jack storage compartment shown in the installation instructions, the trailer harness connector is likely to be located behind one of the tail light assemblies or one of the rear interior trim panels.…

view full answer...

Answer 6

For your 1996 Suzuki Sidekick Sport the Curt hitch you mentioned part #C11024 is the correct fit. It does have a 200 lb tongue weight capacity so you should not tow heavier than that. There isn't an option available with a higher capacity. Doing…

view full answer...

Answer 7

If you wanted to hardware the #HM41245 to your vehicle you'd have to cut the connector off and then use a circuit tester like part #PTW2992 to test the wires of your taillight assemblies for voltage to determine their function. The white wire…

view full answer...

Answer 8

We have a trailer hitch that fits your 1998 Suzuki Sidekick Sport but it's the part #C11024 from Curt and not the #11128 that you mentioned.

view full answer...

Answer 9

I went out to the warehouse to measure Curt trailer hitch #11128 for you and your 1991 Suzuki Sidekick. The overall length is 34-3/8 inches. The mounting holes are spaced 32 inches apart on center side to side and 4-1/8 inches apart on center front…

view full answer...

Answer 10

Curt trailer hitch #C13517 is a custom fit part which is why there aren't any dimensions listed for it. It is designed to fit a 1999 to 2005 Suzuki Grand Vitara, among other vehicles, so dimensionally it is the correct size for your vehicle. If…

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Trailer Hitch Fit for 1997 Suzuki Sidekick Sport

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching