Installation and Operation Instructions for the Curt Stabilization Strap on a 2013 Chrysler 200

Question:

note: All non-trailer loads - bike racks, cargo carriers and so forth - should be supported with stabilizing straps. Failure to properly support these loads will void your hitch warranty from Curt. where is there a pic that shows a set-up with straps included?

asked by: Dean L

Expert Reply:

I can help show you a little better what this strap will look like when installed on your vehicle.

While there is no specific video to your 2013 Chrysler 200, I do have two videos that demonstrate the stabilization strap # 18050 be used with the non-trailer loads, which are going to be most commonly bike racks and cargo carriers.

The Curt hitch # C11133 is a confirmed fit for your 200, but if you would rather not use a strap, like most customers don't when setting up your accessories, then I highly recommend the Draw-Tite # 24871 instead. The Draw-Tite hitch will not require this strap in your setup.

I have linked the above products as well as the installation videos for your viewing and purchasing convenience.

expert reply by: Jackie C