How Much Clearance Do I Need Between My Truck and Fifth Wheel Trailer
Question:
I have 5 1/4 inches between the fifth wheel and the top of my tonneau cover rails. Do I need to set the hitch up another notch or should this be ok?
asked by: Frank L
Expert Reply:
Ideally you will want at least 6 inches between the highest point of your truck bed walls, in your case the tonneau cover rails, and the bottom of your fifth wheel trailer. At 5-1/4 inches you're pretty close and may not have an issue. If you're able to raise it without throwing off the entire rig setup then it would be better. However, if raising your hitch causes any other issues you can keep it where it is but you will want to be careful when going over bumps and uneven ground to avoid any contact.
Product Page this Question was Asked From
Reese 5th Wheel Trailer Hitch - Dual Jaw - 16,000 lbs
- Fifth Wheel Hitch
- Fixed Fifth Wheel
- Aftermarket Below Bed Rails
- 4000 lbs Vertical Load
- 16000 lbs GTW
- Double Pivot
- Standard - Double Jaw
- 13-1/2 - 17 Inch Tall
- Reese
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Q&A: Can I Use A Curt A20 With A Reese Sidewinder On A Ram Truck With The Rambox
- Article: Ram Trailer Tow Prep Package
- Q&A: Does Truck with 6-1/2 ft bed Have to Use Slider Hitch for Turning Clearance with Fifth Wheel Hitch
- Article: 5th Wheel Hitch Installation | The Ultimate DIY Guide
- Article: Gooseneck to 5th Wheel Adapters
- Q&A: Proper Replacement for Reliable ACT-7.5K Brake Actuator
- Q&A: What Is An OEM Prep Package And How Do I Know If I Have It
- Q&A: Wedge For Reese Sidewinder RP34FR & Demco Recon 5th Wheel Hitch
- Article: Fifth Wheel Hitch Combinations for Ram Trucks with RamBox (2009-Current)
- Q&A: Recommended Air Bags and Compressor for a 2002 Ford E-450 Class C
- Q&A: Are Capture Plates Needed When Using the Demco Autoslide With a Lippert Road Armor Pin Box