Can Dexter 23-105 and 23-106 Brake Assemblies be Replaced with Self-Adjusting Assemblies

Question

Question:

I have 23-105/106 brakes on a 2001 HR alumascape TT and would like to convert to auto/never adjust 12x2s. Is this possible? the drums and hubs are good but I have uneven braking and thing its time to reline them and install new magnets

asked by: Gerald W

0

Expert Reply:

You could easily swap out your Dexter manual adjust assemblies part # 23-105 and # 23-106 for a set of self-adjusting assemblies.

For that I would recommend the part # AKEBRK-7R-SA for the right hand side and part # AKEBRK-7L-SA for the left hand side.

These will install in the exact same way as your current assemblies. There would be no modifications needed at all.

expert reply by: Jameson C

0

Answer 1

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 2

Self-adjusting brakes #AKEBRK-7-SA do not require that you travel in reverse for them to adjust. They can adjust themselves going forward or backward. Keep in mind that even self-adjusting brakes require 1 initial adjustment. You could just install…

view full answer...

Answer 3

The #AKEBRK-35L-SA Self Adjusting brake assemblies will adjust themselves as you drive after the initial installation. The front brakes will always bear a bit more of the braking work, because more of the trailer weight is normally on the most…

view full answer...

Answer 4

Trailer brakes can be either self-adjusting like the Dexter #23-468 or may require periodic manual adjustments like #23-27, depending on the particular model assemblies you have installed on the trailer. An easy way to tell if you have self-adjusting…

view full answer...

Answer 5

If you look at the photo I've provided of a self-adjusting brake assembly, you'll see the adjuster cable highlighted. If your trailer brake assemblies feature that adjuster cable, you've got self-adjusting brakes. Each time the trailer…

view full answer...

Answer 6

I contacted Plews and the only suggestion they can give to remove a stuck cartridge is to try to remove it with a pair of pliers. They also mentioned their grease guns like part #L30100 are not compatible with Mystic grease cartridges. You also want…

view full answer...

Answer 7

The biggest difference between the 6,000 lbs Dexter Trailer Brake Assembly part #23-106 for right hand and part #23-105 for left hand and the 7,000 lbs Dexter Trailer Brake Assembly part #23-181 for right hand and part #23-180 for left hand is the…

view full answer...

Answer 8

The two blue lights (see photo) on each side of the Curt Spectrum Trailer Brake Controller part #C51170 will only display when a trailer is disconnected and the brake pedal is applied. You cannot turn this feature off but you can dim it with the…

view full answer...

Answer 9

If you already have a 7-pin connector on the back of your Passport then, by far, the easist solution is the Curt #C51180 Echo Wireless Brake Controller. Simply plug one side into your tow vehicle 7-pin connector and plug your trailer into the other…

view full answer...

Answer 10

The Demco 6-Hole Adjustable Channel Bracket - Weld On - 12" Tall - 21,000 lbs #DM66134 is the weld on option for your trailer. There isn't a complete kit we offer, but it sounds like you are seeking the Demco 50-Degree A-Frame Coupler…

view full answer...

Answer 11

The Curt Spectrum Trailer Brake Controller part #C51170 will illuminate even without a trailer connected that is correct. If you don't wish to see this light each time you hitch the brakes without a trailer attached then you will either need to…

view full answer...

Answer 12

The calibration process of the Curt Spectrum #C51170 should only happen after initial installation and should be run before you plug in the trailer to your tow vehicle. You should have seen the green lights on the knob light up in a clockwise motion…

view full answer...

Can Dexter 23-105 and 23-106 Brake Assemblies be Replaced with Self-Adjusting Assemblies

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching