Over Under Suspension Kit Recommendation for Trailer with 2-3/8 inch Axle
Question:
I have a Wesco boat trailer, 17 ft. boat with 90 hp. Please see picture... axle and springs are not original. Axle is 2 3/8 dia. and measures approx. 85 in. from inside hub to inside hub. GVWR sticker on trailer stamped 2000 lbs. Issues I have: 1. Need more clearance between fender and tire. tires need replacing and are cupped Do you offer a conversion kit that will work with this spring/axle arrangement single eye to raise trailer before tire replacement?
asked by: Joey C
Expert Reply:
Since your axle is 2-3/8 inch diameter you could use the Over-Under Kit, # K71-384-00 to move your axle to the other side of your leaf spring and get additional ground clearance.
These kits can be installed without welding but the manufacturer strongly recommends having the new spring seat tacked in place on the other side of the trailer axle.
When you have cupping wear on a tire it is from the tire bouncing on the road. You will want to check the air pressure in the tire and make sure you are running the maximum air pressure that is indicated on the tire.
Product Page this Question was Asked From
Dexter Trailer Springs Over-Under Conversion Kit
- Trailer Suspension Parts
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Round Axle - 3 Inch
- Dexter
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Raise Your Travel Trailer Height
- Q&A: How to Raise a 5th Wheel Trailer so it Rides Level
- Article: Trailer Tire Sizing
- Article: Double-Eye Trailer Suspension System Review
- Q&A: Can 3,500 lb Axle Trailer Leaf Spring 25-1/4 inch get Replaced with 5k Rated Spring
- Q&A: Recommended Suspension Enhancements for a 2022 Grand Design Imagine 2910BH
- Article: Slipper Spring Trailer Suspension System Review
- Article: Most Popular Wheel Bearings
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: Is it Possible to Raise Suspension of Trailer that Has Slipper Springs
- Q&A: Installation of Dexter Kit # K71-385-00
- Q&A: Do Spring Seats Have to Be Welded to Install Axle Over Under Kit
- Q&A: Replacement Leaf Springs and Wet Bolt Kit For a 2007 Fleetwood Redline 33 Toyhauler