Will Draw-Tite Trailer Hitch be Visible When Installed on a 2008 Lincoln MKX
Question:
The internet photos seem to show that once installed only the receiver is visable from the rear. That is what I am looking for. I do not want the bar to be visable. Is that correct, only the 2 inch receiver is visable?
asked by: Ronnie N
Expert Reply:
The pictures you have seen for Draw-Tite Trailer Hitch, # 75992, are of the hitch installed on a Ford Edge. The Edge shares the same platform as the Lincoln MKX, so the appearance of the trailer hitch will be very similar. The cross tubing should be concealed by the rear lower fascia. I have included a link to the installation details. To make the hitch, including the receiver virtually invisible, I recommend the Lincoln Trailer Hitch Receiver Cover, # AUT-LINC-B, and hitch lock # e98880 to deter theft.
If you plan on doing some towing, the recommended ball mount is # C45010 with a hitch pin # PC3, and you can use ball # 19260 (1-7/8 inch diameter), # 63845 (2 inch diameter), or # 63853 (2-5/16 inch diameter). For trailer wiring, you can use T-One Vehicle Wiring Harness with 4 Pole Trailer Connector, # 118551. I have included a link to the installation details and video install on a similar vehicle below.
Products Referenced in This Question
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
1-7/8" Hitch Ball - 1" Diameter x 2-1/8" Long Shank - Chrome - 2,000 lbs
- Trailer Hitch Ball
- Trailer Hitch Ball
- Standard Ball
- Chrome-Plated Steel
- 1-7/8 Inch Diameter Ball
- 2-1/8 Inch Shank Length
- 1 Inch Diameter Shank
- 2000 lbs GTW
- Class III
- Draw-Tite
more information >
2" Hitch Ball - 1" Diameter x 2-1/8" Long Shank - Chrome - 7,500 lbs
- Trailer Hitch Ball
- Trailer Hitch Ball
- Standard Ball
- Chrome-Plated Steel
- 2 Inch Diameter Ball
- 2-1/8 Inch Shank Length
- 1 Inch Diameter Shank
- 7500 lbs GTW
- Class III
- Tow Ready
more information >
2-5/16" Hitch Ball - 1" Diameter x 2-1/8" Long Shank - Stainless Steel - 6,000 lbs
- Trailer Hitch Ball
- Trailer Hitch Ball
- Standard Ball
- Stainless Steel
- 2-5/16 Inch Diameter Ball
- 2-1/8 Inch Shank Length
- 1 Inch Diameter Shank
- 6000 lbs GTW
- Class III
- Draw-Tite
more information >
Curt Ball Mount for 2" Hitches - 3/4" Rise, 2" Drop - 8-1/4" Long - 7,500 lbs
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- 1 Inch Ball Hole Diameter
- Steel Shank - Gloss Black
- Drop - 2 Inch
- Rise - 1 Inch
- Fits 2 Inch Hitch
- 7500 lbs GTW
- Class III
- CURT
more information >
etrailer Trailer Hitch Receiver Lock for 2" Hitches - Flush - 2-5/8" Span - Chrome
- Trailer Hitch Lock
- Standard Pin Lock
- Keyed Alike
- Chrome
- Fits 2 Inch Hitch
- Flush Pin
- 2-5/8 Inch Span
- etrailer
more information >
Pin and Clip for 2" and 2-1/2" Hitches - 5/8" Diameter x 3-1/4" Span
- Hitch Pins and Clips
- Standard Hitch Pin
- Fits 2 Inch Hitch
- Fits 2-1/2 Inch Hitch
- 5/8 Inch Diameter
- 4 Inch Span
- Draw-Tite
more information >
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 400 lbs TW
- 4000 lbs GTW
- 4000 lbs WD GTW
- 2 Inch Hitch
- 400 lbs WD TW
- Concealed Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Search Results: hitch pins and clips
- Search Results: hitch lock
- Shop: etrailer Hitch Receiver Lock for 2" and 2-1/2" Hitches - Flush - 3-5/8" Span - Chrome
- Q&A: Wheel To Replace Discontinued Lionshead Black Tiger Wheel for Camper
- Q&A: I A Latch For My RV Door That Has A 4-1/2 inch X 4-1/2 inch Hole
- Q&A: Recommended Replacement Grease Seal for 2014 Shorelander Boat Trailer
- Q&A: Trailer Hitch Receiver and 4-Way Flat Vehicle Wiring Harness For a 2024 Ford Maverick
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Why Is a 10" Lube Plate Recommended for a B&W Companion Instead of 12"
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Q&A: Recommended Trailer Hitch Receiver to Tow a Trailer with a 2012 Ford Edge
- Article: How to Choose a Bike Rack for an SUV or Crossover
- Article: Best Bike Racks for Fat Bikes
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)