Confirmation of Fits for Hitch, Wiring and Brake Controller for a 2004 Toyota Tacoma
Question:
Hi, I contacted Etrailer a while back. I need to set up my 2004 Tacoma to haul a trailer with a 7-pin connector and elec. brakes. I think these are the items I need: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2inch - 13013 Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires - ETBC7 Tekonsha Primus IQ Trailer Brake Controller - 1 to 3 Axles - Proportional - TK90160 Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector - C55379 Can you confirm that this is what I need to buy ?
asked by: Jim S
Expert Reply:
Everything you mentioned would be all that you would need for a towing setup on your 2004 Toyota Tacoma.
The Curt hitch part # 13013 is a confirmed fit and then for a 4-way you would want the # C55379. Then to convert the 4-way to a 7-way and install the Primus brake controller part # TK90160 you would want the # ETBC7.
I attached install videos for all products mentioned. The trailer wiring video is actually of a different brand wiring harness but the install process will be the same.
Products Referenced in This Question
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- Custom Fit
- 4 Flat
- CURT
more information >
Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
Tekonsha Primus IQ Trailer Brake Controller - 1 to 3 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 3 Axles
- LED Display
- Up to 90 Degrees
- Tekonsha
more information >
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 500 lbs TW
- 5000 lbs GTW
- 6000 lbs WD GTW
- 2 Inch Hitch
- 600 lbs WD TW
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Can Utility Trailer with 12 inch Wheels/Tires be Replaced with 14 inch Diameter Wheel
- Q&A: Difference Between Curt and etrailer Trailer Hitch Receivers for 2020 Chevy Colorado
- Q&A: What is the Best Grease for Trailer Bearings
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Comparing the Curt Spyder and Curt 25k Gooseneck Trailer Hitches for 5th Wheel Rails
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Q&A: Reasons for 1 Hour 10 Minute Install Time for the CURT Hitch # 13013 on a 2002 Toyota Tacoma
- Article: Trailer Wiring Diagrams
- Q&A: Is there a Replacement for Dexter Nev-R-Lube Hub 008-386-80
- Article: How to Measure for Trailer Hitch Drop
- Article: Rust Prevention