Availability of Winch Strap for Dutton-Lainson # DL15440 3200lb Capacity Hand Winch

Question

Question:

I recently purchased a trailer winch without a strap. So you sell the straps to fit the winches?

asked by: Justin B

0

Expert Reply:

We sure do, you'd need the Dutton-Lainson Hand Winch Strap, part # DL24251. The strap is 20 feet long and plenty of capacity for your winch. If you wanted a strap that's a little longer, you can use part # DL24249 which at 25 feet, is the longest strap that can be used on your winch.

expert reply by: Mike L

0

Answer 1

Generally when picking out a winch for a boat trailer the ratio is 2 to 1 meaning you would need a winch with roughly half the capacity as the weight of the boat. With good rollers and a short winching distance the ratio increases to 3 to 1, but with…

view full answer...

Answer 2

This Dutton-Lainson Hand Winch, part #DL15440, that you referenced would be a good choice to pull your 6500lb truck onto your trailer. You may also be interested in a Fulton Galvanized Winch Cable with Hook, part #FWC3250100, or a Hand Winch Strap…

view full answer...

Answer 3

With a 5,200 pound rated trailer and a 4500 pound boat you are getting to the upper end of the capacity rating for winches with a strap. That is most likely why your winch has a cable installed on it. Some winches are set up so that a cable or a…

view full answer...

Answer 4

The Dutton-Lainson DL2500AB Pulling Winch, part #DL14830, has a rated horizontal pulling capacity of 2500 pounds. It is not rated adequately to pull your 3020-lb boat onto its bunked trailer. We offer the 3200-lb-rated Dutton-Lainson model DL3200A,…

view full answer...

Answer 5

Yes, the Hand Winch Strap with Safety Hook part #DL24251 will work just fine with the Dutton-Lainson Hand Winch part #DL14725. However, please note that you will be limited to the weight capacity of the winch which is 2,000 lbs because it is lower…

view full answer...

Answer 6

We have some very similar winches to the Shelby 5466 that you have but we do not carry Shelby winches any longer. The Shelby is a 2 speed winch with a 2,300 lb capacity so for a very similar winch we have the Dutton Lainson 2 speed winch part…

view full answer...

Answer 7

I spoke with my contact at Dexter and he said the 21-37 oil cap is obsolete and was replaced with the 21-36 oil cap, #RG04-270. This cap includes the o-ring and plug.

view full answer...

Answer 8

We don't carry the Shelby 5408 winch, but from what I see they are the same mounting holes as the Dutton-Lainson Hand Winch with TUFFPLATE Finish, Two Speed with Direct Drive - 3,200 lbs #DL15440. I've attached a picture of those measurements…

view full answer...

Answer 9

Generally when picking out a winch for a boat trailer the ratio is 2 to 1 meaning you would need a winch with roughly half the capacity as the weight of the boat. With good rollers and a short winching distance the ratio increases to 3 to 1, but with…

view full answer...

Answer 10

We do not carry the Shelby winch line since they went out of business. We do have the Dutton-Lainson Hand Winch #DL15440. I have attached a photo that shows the mounting pattern for the winch you can check out. You can check the measurements to see…

view full answer...

Answer 11

I do have some options for you but there isn't a plug under the dash for a trailer brake controller on a 2023 Chevrolet Traverse. Therefore, if you want to use a traditional dash mounted trailer brake controller you must hardwire which requires…

view full answer...

Answer 12

The Dutton-Lainson Hand Winch - TUFFPLATE Finish - 2 Speed - Direct Drive - 2,500 lbs #DL14830 will only ratchet when being pulled in. The output will free-wheel and allow you to control that free-wheel speed with the integrated hand brake. The hand…

view full answer...