Replacement Bearing Recommendation for Bulldog Square Jack 190708

Question

Question:

I have a bulldog 190708 What bearing replacement do I need? Thanks

asked by: Bulldog J

0

Expert Reply:

The correct replacement bearing for the Bulldog Square Jack # BD190708 is the part # BD500224.

expert reply by: Jameson C

0

Answer 1

I see that you got the Replacement Cap for etrailer and Ram Square, Sidewind Jacks #TJD-7000S-CP, which indicates that you have a square side crank jack. I have listed the square jack thrust bearings that we have below, along with their OD/ID, we…

view full answer...

Answer 2

I do have several replacement parts available for the RAM Trailer Jack part #TJD-7000S but not an all inclusive rebuild kit. Instead you will need to select from the components listed below and repair the jack as needed. The most common fault on…

view full answer...

Answer 3

You are needing the Replacement Sidewind Gear Kit #BD5002581360 which will include the hex pattern thrust washer for the handle side of your Fulton Marine Jack #HD50000101.

view full answer...

Answer 4

There can be many reasons a trailer jack might bind and cause the center pin to be sheared off from the handle. The more common causes is if the jack is overloaded, if the lower inner tube is bent, or if debris has gotten into the gears or bearing.…

view full answer...

Answer 5

Absolutely! I reached out to my contact at Fulton and for your Fulton 2840025 you will need the following parts: Gear Kit #BD500106 Bearing Kit #BD500224 Replacement Handle Kit #BD500171 Replacement Cap #BD500205 The handle kit that was originally on…

view full answer...

Answer 6

The round or trunnion bars refers to the end of the spring bars. Round bars are typically designed for lighter applications, are a bit harder to install and are usually priced lower than trunnion bars. Trunnion bars are typically designed to be used…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 11

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 12

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Replacement Bearing Recommendation for Bulldog Square Jack 190708

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching