No 12 Volt Power at Trailer Connector on a 2008 GMC Sierra
Question:
What if it shows power at the box and not at the end of the plug?
asked by: Paul
Expert Reply:
You may need to make some connections under the hood on a 2008 GMC Sierra to make everything fully functional. I have included a link to an article that will help.
If this does not solve the problem then there could be a break in the wire somewhere. If you cannot track down and fix the break then the other solution is to bypass it by running your own wire, # 12-1-1 sold by the foot, from the back of the connector to the positive battery terminal via a 40 amp circuit breaker, # PK54540.
Products Referenced in This Question
Pollak Circuit Breaker - Cycling/Automatic Reset - 40 Amp - Straight Mount Bracket
- Accessories and Parts
- Wiring
- Circuit Breaker
- 40 Amp
- Pollak
more information >
Product Page this Question was Asked From
Pollak Metal 7-Pole, RV-Style Trailer Socket - Vehicle End
- Trailer Wiring
- Trailer Connectors
- Vehicle End Connector
- Plug Only
- 7 Round - Blade
- Pollak
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Do 8k Oil Bath End Caps On Lippert Axle Interchange With Dexter End Caps
- Q&A: Recommended Electric Over Hydraulic Brake Set Up for 2016 Montana 3710FL 5th Wheel
- Q&A: Replacement Grease Seals For TRP GS-1719DL
- Q&A: Is Adapter Needed to Install Dometic Water Heater # DMC74FR In Place of Atwood
- Article: Brake Controller Installation: Starting from Scratch
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Printable Trailer Bolt Hole Pattern Template
- Q&A: Do I Need Brakes On Both Axles of a Car Hauler Trailer?
- Q&A: Recommended Wet Bolt and 2-1/4" Shackle Strap Kit for Tandem Axle Trailer
- Q&A: Leaf Spring Recommendation for 4,400 lb Trailer Axle
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Article: Hitch Adapters and Extenders
- Article: Troubleshooting Brake Controller Installations