Recommended Rear Coil Helper Springs for 1999 Honda CR-V

Question

Question:

Can I use them in my Honda CR-V 1999

asked by: Martin

0

Expert Reply:

In your 1999 Honda CR-V you can use SumoSprings Custom Helper Springs # CSS-1069R in the rear coil springs to add suspension support. These install without drilling and fit both 2WD and 4WD versions of your CR-V. They are designed to work with a suspension system that is in good working order to provide additional stiffness when under load.

The Super Springs Coil Custom Helper Springs # CSS-1125R fit later model years of the CR-V but not your 1999.

expert reply by: Adam R

0

Answer 1

From what I've been able to determine by looking at the online instructions for that Subaru Outback Hitch Panel, it appears that the OEM Subaru hitch sits up further on the vehicle, so the receiver tube exits through a hole in the bumper fascia,…

view full answer...

Answer 2

I do have a solution to not only prevent sway while towing your boat trailer with the 2018 Subaru Outback Wagon but also prevent sag. The Coil SumoSprings part #CSS-1125R are good for leveling out the vehicle and helps to reduce body roll but are not…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hey Stephen, I would go with the SumoSprings kit part #CSS-1125R if you prefer a zero maintenance solution that once you install it you can basically never have to think about it again. The Air Lift air bag kit part #AL29PD would also work but it…

view full answer...

Answer 7

Yes and no. The RockyMounts AfterParty Swing Away Bike Rack #RKY37ZR can be used if your bike has a smaller fender, but if it's a larger fender that covers most of the tire then it won't work as the clamps will damage the fenders. I'm…

view full answer...

Answer 8

The Loadstar ST235/75R15 Radial Off-Road Tire w/ 15" Black Mod Wheel item #KE88JR will work great as a spare tire for your Rove 14FL travel lite trailer. It weighs 66 lbs. The wheel tire combo does not come balanced but you can use the…

view full answer...

Answer 9

If you can provide me with some measurements of your coil springs, I can determine if any of our SuperSprings Coil Inserts will work on your 2009 Subaru Legacy. Unfortunately SuperSprings has not tested any of their coil inserts with your vehicle,…

view full answer...

Answer 10

The #CSS-1168R and #CSS-1195F are only confirmed to fit the FWD models but that doesn't mean there aren't Coil SumoSprings for your 2023 Sienna AWD. To find the right size you will need to measure the gap between in the middle of the coil.…

view full answer...

Answer 11

I have a solution for you, but there isn't a spare tire carrier that is confirmed to fit the Inno Shaper 80 Roof Cargo Basket INXA568, so I do not recommend using the Rhino Rack Spare Tire Carrier #RSWH with it. For a platform rack that will…

view full answer...