Bushing Recommendation for a Camper Trailer Leaf Spring

Question

Question:

I am installing the wet shackle bolts on my camper. Which spring bushings should I use with them? Bronze, plastic or forever bushings? Thank You,

asked by: Frank C

0

Expert Reply:

I would go with the Never Fail Bushing like part # TRBU11566 as it is self lubricating and maintenance free. You basically wouldn't even need the wet bolts. Right now we only offer these in one size, 9/16 inner diameter, 11/16 outer diameter, and 1-5/8 inch overall length. This is the most popular size needed though.

If you need a different size check out the link I attached to see all our bushings. You will then be able to select the size you need from the filters.

expert reply by: Jameson C

0

Answer 1

The spring pins on the Lippert Solid Stance RV Step Support Kit #LC96BJ are supposed to face the other direction on the step. This ensures they will fold in past the other steps and also helps prevent your toe from getting caught up on the pin as…

view full answer...

Answer 2

Increasing the tire and wheel size can increase the height of the trailer but it's usually quite minimal. Before you do anything else you should see if the pin box can be adjusted. Although you have to be careful here since This will lower…

view full answer...

Answer 3

Hey Dave, the MORryde upgraded shackle kit part #MR76ZR that you referenced is compatible with your 2020 Grand Design 2670MK and the Lippert Road Armor equalizers.

view full answer...

Answer 4

There is no specific torque rating for shackle bolts. Basically for the middle bolt there should be enough free play in the shackles to allow them to move. Tightening the shackle bolts too much will squeeze the shackle straps against the leaf springs…

view full answer...

Answer 5

Kenny, those bolts for the B&W Companion 5th Wheel Trailer Hitch #BWRVK3500-5W should be torqued to 40 ft. lbs. Also, the pivot arms would need to be torqued to 80 ft. lbs, the draw down bolt should be tighten to 60 ft.lbs and the arms should be…

view full answer...

Answer 6

It really just depends on what you are looking to get out of the bushings. Bronze bushings, like part #K71-291-00, will last longer but are more noisy and it is recommended to use wet bolts like part #126B2 to keep them lubricated. Nylon bushings,…

view full answer...

Answer 7

The side plates of the B&W gooseneck trailer hitch #BWGNRK1313 will mount on the outside of each frame rail of your 2004 Dodge 2500 8-foot bed. See the B&W video I included at the 7 min and 30 second mark. If your Firestone air bags like…

view full answer...

Answer 8

Trailer manufacturers don't usually keep a record of parts like these that they install at the factory, so I cannot be sure as to the exact length of the shackle strap that would have come originally on your trailer. With this in mind, a 3-1/8…

view full answer...

Answer 9

The 4,400lb axles will share some of the same components as the 3,500lb axles. It is a good idea to check your sizes ahead of time to ensure you get the exact product that you need(see article and picture). Here is what we show fitting your 2021…

view full answer...

Answer 10

Yes, it is a good idea to go ahead and add grease when installing the Suspension Kit for Tandem-Axle Trailers - 1-3/4" Wide Double Eye Springs - 2-1/4" Links #AP233. You don't want to use fat though, just go ahead and use the LubriMatic…

view full answer...

Answer 11

Well shackle length is mainly based on the height difference between the front and rear hangers. The rear hanger normally doesn't hang as low as the front so that the shackle can offset the difference and add the ability to move. What is the…

view full answer...

Bushing Recommendation for a Camper Trailer Leaf Spring

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching