Where Does a Brake Controller Plug Into on a 2013 Toyota Tacoma
Question:
I have a 2013 Tacoma with the trailer package and I cant find the brake controller adapter/harness. Nor can I find any information on line for the 2013 model. I have looked just to the left of the emergency brake and can not find any connecter. Can you help, please.
asked by: Bill B
Expert Reply:
For your 2013 Toyota Tacoma and a Tekonsha brake controller the correct brake controller wiring harness is # 3040-P. In plugs into a plug on the truck located under the dash to the left of the emergency brake pedal.
Some times the factory plug can fall behind the driver's side kick panel or be tucked up higher and attached to another wire bundle. I have included a link to a video that shows the general area it is located. It is on a 2012 Tacoma which will be the same as on a 2013.
If your Tacoma did not come with a factory 7-Way trailer connector then it is possible that the harness is not there and the brake controller would have to be hardwired in.
Product Page this Question was Asked From
Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers - Toyota and Lexus
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Vehicle Specific
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Hitch
- Search Results: trailer door hinges
- Shop: Replacement Cables for Conventional Ramp Door Spring - 150" Long - Qty 2
- Shop: Trailer Wiring
- Shop: Replacement Trailer Brake Magnet Kit for Dexter and Hayes / AL-KO 10" Trailer Brakes
- Shop: Bent Roller Ramp Door Hinge Pin - 10" Long - 3/4" Diameter
- Shop: Replacement Trailer Brake Magnet for Dexter Electric Brake Assemblies
- Shop: Replacement Magnet Kit for 10" Electric Trailer Brake Assemblies - 3,500 lbs
- Search Results: ramp door cables
- Search Results: continuous hinge
- Search Results: ramp door assist spring
- Shop: Tandem Axle Jeep Style Trailer Fenders - Cold Rolled Steel - Qty 2
- Shop: Conventional Ramp Door Spring for 8' Wide Enclosed Trailer - Dual Spring - 150-lb Capacity
- Search Results: k71~698~00
- Search Results: 023~479~00
- Search Results: k23~479~00
- Q&A: Spring Hanger and Axle Diameter Measurements for Installing Leaf Springs on Single Axle Trailer
- Q&A: Hanger Spacing for 3500 LB. Tandem Axle Trailer
- Q&A: Tandem Axle Trailer Suspension System Dimensions for Best Function
- Q&A: How to Determine Hanger Spacing for Tandem Axle Trailer Suspension with 26 Inch Springs
- Q&A: Trailer Hitch Receiver And 4-Way Vehicle Wiring Harness For a 2024 Mazda CX-90 PHEV
- Q&A: Trailer Hitch and Wiring Kit Recommendation for a 2024 Mazda CX-90
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Article: How to Choose the Right Trailer Hitch Class
- Video: Choosing the Right Trailer Wiring
- Article: Trailer Wiring Diagrams
- Video: Choosing the Right Brake Controller
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Brake Controller
- Shop: Fifth Wheel Hitch