Center-To-Center Measurement For Mounting Holes On Bulldog Collar-Lok Coupler
Question:
I am looking for a replacement but I need to know the bolt hole dimensions from center to center of each hole. Thank you
asked by: Bill
0
Expert Reply:
I went to the warehouse and measured the distance between the mounting holes on the Bulldog Collar-Lok Coupler, part # BD028585.
The center-to-center distance is 2 inches. This coupler mounts in a 3 inch channel bracket and is 10 inches long. The ball size this coupler is designed for is 2-5/16 inches.
expert reply by:
Jeffrey L
0
click to enlarge
Product Page this Question was Asked From
Bulldog Collar-Lok Coupler - Gray - Adjustable Channel Mount - 2-5/16" Ball - 12,500 lbs
- Adjustable Trailer Coupler
- Coupler Only
- 12500 lbs GTW
- 2-5/16 Inch Ball Coupler
- Pin-Style Fastener
- Bulldog
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Correct Replacements for Dexter 023-359-00 Left Hand and 023-360-00 Right Hand Braking Assemblies
- Q&A: Could Bulldog and Curt Channel Coupler Fit in Lock N Roll Channel
- Q&A: Wiring Diagram for Dometic Single Zone Thermostat and Control Box
- Article: Trailer Wiring Diagrams
- Q&A: Comparing Dexter E-Z Flex and MORryde SRE4000 Cushioned Equalizers for 7K Axles
- Q&A: MORryde CRE3000 or Dexter E-Z Flex Trailer Suspension Equalizers?
- Q&A: How to Determine Hanger Spacing for Tandem Axle Trailer Suspension with 26 Inch Springs
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: Replacement E-Z Lube 4" Drop Spindle for 3,500LB Leaf Spring Trailer Axle
- Article: Double-Eye Trailer Suspension System Review
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller Installation on a Ford Full-Size Van
- Article: How to Raise Your Travel Trailer Height
- Article: 2023 Best Gifts for Haulers & Towers