Will Electric A-Frame Tongue Jack # LC285318 Clear the Propane Tanks on a Trailer
Question:
Am trying to figure out if this jack will clear my propane tanks and wont effect my clearance as its pretty tight when getting the trailer in/out of drivway. What is the length of the bottom of the bracket to the bottom of the jack when fully retracted? And also what is the dimension from the center of the jack to the back most part of the jack housing? Thanks
asked by: Craig
Expert Reply:
I went out to the warehouse to take some measurements on the Electric A-Frame Tongue Jack, # LC285318. When fully retracted, the distance from the jack foot to the bottom of the mounting bracket is 10-3/8 inches.
From the center of the jack to the back of the housing is 2-3/4 inches. The distance from the center of the jack to the front of the housing is 6-3/4 inches.
From the bottom of the housing to the top of the bracket is 10-3/8 inches.
Product Page this Question was Asked From
Lippert Electric Trailer Jack with Footplate - A-Frame - 18" Lift - 3,500 lbs - Black
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jack
- Steel
- 3001 - 4000 lbs
- Electric Jack
- Bolt-On
- 1 Jack
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Weight Distribution Recommendation for a 2024 Jayco Flight 284BHS
- Q&A: Replacement 3500-lb Electric Tongue Jack for Lippert 1817941
- Q&A: Hitch Extender For 2-1/2 Inch Hitch For Weight Distribution
- Q&A: Lowest-Profile A-Frame Trailer Jack For Tailgate Clearance
- Q&A: Replacement For A-Frame Tongue Jack on Lippert Electric Ground Control TT
- Article: RV Pre-Departure Checklist
- Q&A: Replacement Toggle Switch For Lippert Power Stance Trailer Jack
- Article: Trailer Wiring Diagrams
- Q&A: Correct Replacement for an Atwood Water Heater GC6AA-9E
- Article: Trailer Jacks
- Article: How (and Where) to Connect an RV Propane Grill
- Article: Most Popular Wheel Bearings
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: How to Measure for Trailer Hitch Drop