Trailer Wiring Harness 118624 Only Plugs Half Way Onto a 2013 Land Rover Evoque
Question:
Socket 118624 do not fit in the 8 socket original Evoque 2013 wiring I removed the small protector and try to fit . It come trought just half ,not enough to connect
asked by: Pierre
0
Expert Reply:
Is there room for the connector on # 118624 to go on any further or does it stop half way? It will be a tight fit and it might take a little more muscle to fully seat the 2 connectors. You could use some dielectric grease, # LT37534, on the connections and it could make sliding it on easier and provide moisture protection.
expert reply by:
Michael H
0
Products Referenced in This Question
Loctite Bulb, Lamp, and Electrical Connection Dielectric Grease - 0.33-Oz Tube
- Accessories and Parts
- Wiring
- Dielectric Grease
- Loctite
more information >
Product Page this Question was Asked From
T-One Vehicle Wiring Harness for Factory Tow Package - 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- No Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Flat Towing Package for 2018 Jeep Wrangler JL and JL Unlimited
- Q&A: Routing Wiring for T-One 4-Way Harness on a 2015 Land Rover Evoque
- Q&A: Trailer Lights Wont Work After Wiring Harness Install on a 2001 Lexus RX300
- Q&A: Location of Install Connector for Trailer Wiring on a 2012 Land Rover Evoque
- Article: Wiring a Tow Vehicle to Tow a Dinghy
- Q&A: Trailer Wiring Harness Recommendation for a 2013 Land Rover Evoque
- Q&A: Hitch & Wiring for 2010 Toyota Prius to Tow Small Aluminum Boat Trailer
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Q&A: Which Trailer Wiring Harness Fits 2012 Land Rover Range Rover Sport HSE
- Q&A: What is the Difference Between a Class II and a Class III Hitch?