What are the Yakima Side Loader Mounting Brackets for Raingutter Towers Made Of

Question

Question:

are these aluminum or steel?

asked by: Joe

0

Expert Reply:

The Side Loader Mounting Brackets # Y08002 are steel. They are designed for you with the Yakima Raingutter towers # Y00101.

expert reply by: Michael H

0

Answer 1

When mounting rain gutter towers, #Y00101, there is no specific distance apart they must be placed. What you will want to look at is where you can mount them (the strongest points on the roof would be ideal) and how far apart you need them to mount…

view full answer...

Answer 2

I have a solution for a roof rack and kayak carrier for your 2016 Ford F-150 Super Cab. I recommend the Yakima JetStream Roof Rack System, #Y00426 JetStream Crossbars, #Y28TR BaseLine Towers, and #Y06122 BaseClip Fit Kit. The JetStream bars are an…

view full answer...

Answer 3

I went out into our warehouse to grab a set of the part #TH542 that we had in stock and determined that the plates of this kit are aluminum.

view full answer...

Answer 4

The INNO square bars are the same shape as the older Thule square crossbars that didn't have the channel that ran on the underside of the bar. So for a longer crossbar setup you could use the part #IN436L for a 79 inch bar.

view full answer...

Answer 5

The reality is that both the Yakima and Thule artificial rain gutters were designed to mimic the same thing so they would work between each other. The rain gutters they tried to emulate is a universal design. So either the #TH542 or #Y08002 would…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

For a roof rack to be compatible on your 2020 Jeep Wrangler with Sky One-Touch Power Top, it can't be mounted on the top of the roof and it needs to be high enough for the folding roof to clear. What you need are tall gutter-mounted roof racks.…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 12

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...