Journey Brake Controller Shows No Power on Blue Wire with Brake Pedal Pressed
Question:
I have power at the red wire when brake pedal depressed, and blue wire shows no current at all?
asked by: Scott M
Expert Reply:
Try applying the manual override when testing the blue wire instead of the brake controller. Some brake controllers have to sense movement to send power back along the blue wire.
In the truck cab you will need to sever the blue wire several inches from the back of the controller. Then use a circuit tester such as #PTW2993 to test the end of the blue wire coming out of the controller. It should only have power when you apply the manual override. If it shows power at idle, then there is something wrong with the controller and it will need to be replaced.
If it tests fine, then reconnect the blue wire. Then move on to the truck side trailer connector. Many times, dirt or corrosion can cause a short in a trailer connector. Make sure the truck and the trailer side connectors are clean and free of corrosion inside and out.
You can test the brake output pin and it should only show power with the manual override. If it shows power any other time, then there is a short somewhere between the connector and the brake controller you will need to track down.
If the truck side checks out fine then it could be the wiring to the brake magnets or the magnets themselves. Inspect the power wires to the magnets and look for pinched, frayed, or damaged wires and fix as needed. Make sure the ground wires are attached to clean and corrosion free bare metal surfaces.
You can visually inspect the magnets and if you can see the copper windings coming through the magnets will need to be replaced. To further test the magnets you can follow the help article I have linked. I have also included some help articles on testing and troubleshooting brake controllers for you.
Products Referenced in This Question
Product Page this Question was Asked From
Wiring Kit for 2, 4, 6, and 8 Brake Electric Trailer Brake Controllers
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Wiring Diagrams
- Q&A: Wiring and Circuit Breaker Kit for 4-Way/7-Way Connecter to Add a Brake Controller
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: My Vehicle has a 4-Pin Trailer Plug, but Trailer has 7-Pin Trailer Plug
- Q&A: Installing Wiring for an Electric Brake Controller on an Isuzu N-Series Truck
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Parts Needed For Tekonsha Prodigy P2/P3 Trailer Brake Controller on 2001 Ram 1500 No Tow Package
- Q&A: Parts Needed to Activate 12 Volt Charge Circuit of 7-Way on 2022 Tiffin Wayfarer on Sprinter Chassis
- Q&A: Installing A Reese Brakeman Controller In A 202 Ford E250 With Factory 4-Flat
- Q&A: Parts Needed to Install Redarc Tow Pro Elite in 2008 Dodge Sprinter with 7-Way
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer