Diameter of Replacement Lens for BU40CB and BU41CB

Question

Question:

What is the diameter?

asked by: Bill

1

Helpful Expert Reply:

I went out to the warehouse to measure this lens and found the diameter of Replacement Lens # A41CB to be 4-1/4 inches.

expert reply by: Victoria B

1

click to enlarge

Answer 1

The UWS Truck Bed Toolbox - Crossover Style - Single Lid Series - 6.9 cu ft - Gloss Black #UWS00327 or bright aluminum #UWS00076 are the TBS-54 options. There are also two low profile options in the #UWS00371 or #UWS00381. All of these installations…

view full answer...

Answer 2

When closed the lock #UWSTWISTLOCK is 1-7/8 inches tall and 1-1/2 inches wide. I included a picture showing this and other relevant measurements for you.

view full answer...

Answer 3

The Replacement Tail Light Lens #A40RB is not held on with screws. The outer bezel housing of the 4-1/2" Round Trailer Stop, Turn and Tail Light, Flange Mount, 3-Function #ST40RB for instance has the housing held by screws and the lens is held…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 10

Yes, because it is a 3-wire light, you can wire the Red Identification Light Bar with White LED Utility Light #OPT88FR to function as rear marker and reverse lights.

view full answer...

Answer 11

Increasing the tire and wheel size can increase the height of the trailer but it's usually quite minimal. Before you do anything else you should see if the pin box can be adjusted. Although you have to be careful here since This will lower the…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Diameter of Replacement Lens for BU40CB and BU41CB

Product Page this Question was Asked From

Continue Researching