Does Ultra-Fab Solar-Powered Plumbing Vent for Motor Homes have an On/Off Switch

Question

Question:

Does this have an of/off switch?

asked by: Nate B

1

Helpful Expert Reply:

No the solar-powered plumbing vent # UF53-945001 does not have a switch to turn it on and off. It is meant for vent pipes from holding tanks and not for standard or bathroom use so it doesn't need a switch.

expert reply by: Michael H

1

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 4

The Replacement Single Zone Thermostat for Dometic RV Air Conditioners #DMC79FR is a single zone 3 wire thermostat like the one you are describing. I have attached the wiring diagram for this thermostat and the control box below for your reference.

view full answer...

Answer 5

We have the Ultra-Fab Solar-Powered Plumbing Vent for Motor Homes - 7" Diameter x 3-3/4" Tall #UF53-945001 which is designed to be mounted on the roof. My recommendation is to use this roof vent and allow your side vents to stay as they…

view full answer...

Answer 6

The Roadmaster Nighthawk tow bar part #RM-676 is a great option for a tow bar for your 2022 Jeep Wrangler 4xe but you will need to install a base plate kit on your Jeep. For that you'd want the Roadmaster Direct Connect part #RM-521453-5 and that…

view full answer...

Answer 7

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory 7-way…

view full answer...

Answer 8

Yes indeed. Adding some suspension enhancement helper springs such as #SSR-187-54-1 to your 2017 Fleetwood Bounder on the Ford F-53 chassis will make it even more stable. They will help with body roll which is what happens when wind gusts blow…

view full answer...

Answer 9

The bearings you would need are inner bearing #LM67048, outer bearing #L44649 with a #10-42 seal. We don't have this as a kit but you can order each individually.

view full answer...

Answer 10

The diameter of your trailer axle will determine the size of the parts that you will need to order for an axle over under kit. If your axle is 3 inches diameter, the Dexter Trailer Springs Over-Under Conversion Kit, #K71-385-00, would be a great…

view full answer...

Answer 11

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Does Ultra-Fab Solar-Powered Plumbing Vent for Motor Homes have an On/Off Switch

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching