Which Spare Tire Cover for ST215/75-14 Tire

Question

Question:

My tire size is st215-75r14 what model number do i need and does it come in white

asked by: Ed

0

Expert Reply:

A 215/75-14 tire would be about 26-3/4 inches in diameter. I'd recommend going with the Classic Accessories Spare Tire Cover, part # 052963751307 which fits tires that are between 26-1/2 and 27-1/2 inches in diameter. The cover is Snow White in color.

expert reply by: Mike L

0

Answer 1

The Rampage Spare Tire Cover part #RA773215 or the Rampage Display Spare Tire Cover part #RA783235 are an exact fit for a 31x10.5-15 tire on a Jeep Wrangler. These covers are both made of 19-oz fabric so they will be durable and hold up well to…

view full answer...

Answer 2

We recommended to repack the wheel bearings on your trailer every 12 months or 12,000 miles. There is not a specific guideline as far as actually replacing the bearings. When repacking them with grease, you will also just want to check for any…

view full answer...

Answer 3

The magnet should only make contact with the inside of the brake drum when power is applied to the magnet. If it is making contact with the drum all the time, you may have residual power running on the brake wire that is just enough to cause the…

view full answer...

Answer 4

Since the trailer was off of the ground it would not take much voltage to stop the wheels from spinning so they may be getting power but they may not be getting enough power due to a short or wiring issue. But 9 times out of 10 weak trailer brakes…

view full answer...

Answer 5

Yes, electric brake assemblies will work in reverse. The brake controller in your tow vehicle would still activate in reverse as long as the brakes are applied. The actuating arm of the Dexter assemblies part #23-27 will apply the brakes when…

view full answer...

Answer 6

If the brake magnet is worn to the point that the windings are visible then you know it's time to replace the magnet. However, magnets can also fail without the visible signs of wear. Check out the FAQ article I attached on testing brake…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13…

view full answer...

Answer 10

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures…

view full answer...

Answer 11

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Which Spare Tire Cover for ST215/75-14 Tire

Product Page this Question was Asked From

Continue Researching