Installation Instructions for Classic Accessories StormPro Pontoon Boat Cover # CA20027

Question

Question:

I just received my new cover from etrailer and I am very pleased with the cover. I have misplaced the instructions that came my cover. I tried to find them online but did not. Can you direct me or email me a copy? Thank you for your time.

asked by: William

0

Expert Reply:

Thanks again for shopping with etrailer! I'm very glad to hear that you are pleased with your purchase.

I have attached a snapshot of the instructions for the Classic Accessories StormPro Pontoon Boat Cover, # CA20027.

expert reply by: Leah S

0

click to enlarge

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

Good morning, Cliff. As of today (3/27/24) we are expecting the #KE33JR tire/wheel combo to be in stock in about 2 weeks. Hopefully this means we can take our own pictures and put them on the site within maybe about 3-4 weeks from now. What I can…

view full answer...

Answer 6

Trailer wiring generally uses 16 gauge wire, part #16-1-1. However, with a long trailer like yours you may want to go with a larger like 14 gauge #DW07550-1 or even 12 gauge #12-1-1. Each size is sold by the foot. You will need to have the lights at…

view full answer...

Answer 7

You would need to have a reverse light circuit ran to your trailer to power reverse lights. If you have a 5-way flat or 7-way trailer connector currently then that circuit is already present. If you have a 4-way harness then you would need to install…

view full answer...

Answer 8

For a replacement lens for the trailer taillight kit part #TLL160RK you'd need the part #A16RB.

view full answer...

Answer 9

The Classic Accessories StormPro Pontoon Boat Cover, #CA20027, can be used when transporting your boat, but how it holds up depends on a lot of factors. Things like speed, road and weather conditions all will play a part in how the cover responds to…

view full answer...

Answer 10

The CE Smith Roller Style Guide-Ons for Pontoon Boat Trailers part #CE27672 can be installed at the rear of the trailer or towards the center. That said, the further back they are installed the better they will do to help guide the boat on. I have…

view full answer...

Answer 11

The 215/75-14 tires that you have now are 26.7" diameter x 8.5" wide and the 205/75-14 tires that you are inquiring about are 26.1" diameter x 8.1" wide. Therefore, you should not have any clearance issues. However, there are also…

view full answer...

Installation Instructions for Classic Accessories StormPro Pontoon Boat Cover # CA20027

Product Page this Question was Asked From

Continue Researching