Spare Tire Cover Recommendation for a 185R14 Tire

Question

Question:

I have a 185R14 spare tire. It measures at 25x7.5 but your notes on this cover says its for a 13inch tire. Will it work for a 14inch or do you recommend a different cover?

asked by: Teresa

0

Expert Reply:

If your tire measures 25 inches in diameter and 7-1/2 inches in width the Spare Tire Cover part # CE27420 would fit well regardless of the wheel size. All that matters is overall tire size.

expert reply by: Jameson C

0

Answer 1

I looked up the hose and the regulator you currently have, and found that the GHA7 hose uses an ACME Nut connector to the LP tank and a 1/4 inch male inverted flare that connects to the 3/8 to 1/4 adapter used on the regulator. We offer the necessary…

view full answer...

Answer 2

I was able to find the tire size on a 2017 model is ST205/75R14C and the bolt pattern is 5 on 4-1/2 inches. So for your spare, you will want the Castle Rock ST205/75R14 Radial Tire w/ 14" Condor Aluminum Wheel - 5 on 4-1/2 - LR C - Gunmetal…

view full answer...

Answer 3

The Replacement Water Valve for Dometic Pedal Flush RV Toilets #DOM93FR that you were looking at is confirmed to fit Dometic model 300 toilets. Since you have the Dometic 300 toilet, this will fit.

view full answer...

Answer 4

It looks like the Flame King regulator you mentioned has a 1/4" female inverted flare inlet, so yes, it is going to be compatible with the MB Sturgis hose you asked about which has a 1/4" male fitting, MB Sturgis Propane Pigtail - Type 1 x…

view full answer...

Answer 5

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 6

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 7

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

view full answer...

Answer 8

To see all of the correct wheel and tire combos you'd need check out the link I attached. The option I would recommend is the part #TA43RR which is a Load Range C tire size ST175/80R13 mounted on a white spoke wheel with a bolt pattern of 5 on…

view full answer...

Answer 9

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 10

Yes, the Solera Slide Topper part #LCV000168106 is the correct fit for your flange width of 90-1/2 inches. This specific model has a box width range of 86 to 91-3/4 inches which is perfect for your width listed.

view full answer...

Answer 11

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 12

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Spare Tire Cover Recommendation for a 185R14 Tire

Product Page this Question was Asked From

Continue Researching