Eye Bolt Recommendation for Mounting in Roof Rack Crossbar Tracks

Question

Question:

Does Yakima sell, or do you know of, an eye bolt that screws directly in to the Yakima Replacement Anchor Plate Style-A?

asked by: David A

1

Helpful Expert Reply:

If you are looking for a set of eye bolts that can mount in the tracks of roof rack crossbars you would want the part # S604.

expert reply by: Jameson C

1

Answer 1

While the Eyebolts for Rhino-Rack Aero/Sportz Crossbars #S604 don't have a weight capacity stated they were designed for use on roof racks with a dynamic weight capacity of 165 lbs. So based on that if you were to use them as a way to suspend a…

view full answer...

Answer 2

Yes the Eyebolts for Rhino-Rack Aero/Sportz Crossbars #S604 fits the top channels of a TracRac ladder rack as well.

view full answer...

Answer 3

The Dexter Nev-R-Adjust electric trailer brakes can be manually adjusted. There are a couple teeth of the adjustment wheel that are exposed just under the lever that you referenced. I have attached a photo showing the teeth. You will likely need a…

view full answer...

Answer 4

We've actually had this question a few times and the Rhino Rack Eyebolts part #S604 do fit into the top channel of Thule crossbars like what you have.

view full answer...

Answer 5

Yes! You can use Rhino-Rack eyebolts #S604 in the Whispbar T-slot. I have included a picture a coworker took showing the two parts are compatible.

view full answer...

Answer 6

Yes, the Replacement M8 T-Bolt part #853-5715 will fit properly within the channels on the Thule Evo WingBar Crossbars. If you are looking for the correct Thule Evo WingBar System to use on your 2019 Kia Niro then you will need to obtain either part…

view full answer...

Answer 7

The anchor plates that fit into Yakima roof tracks are the part #Y8810074 which is 3/4 inches wide. This is the same width as the anchor bolts of the #Y01162 which is designed to fit Yakima crossbar top channels. So the #Y01162 would work well…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

For a roof rack to be compatible on your 2020 Jeep Wrangler with Sky One-Touch Power Top, it can't be mounted on the top of the roof and it needs to be high enough for the folding roof to clear. What you need are tall gutter-mounted roof racks.…

view full answer...

Eye Bolt Recommendation for Mounting in Roof Rack Crossbar Tracks

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching