Air Suspension Enhancement Recommendation for a 1999 GMC P30 Motorhome

Question

Question:

Im looking for information about installing your air shock assist bags on my 1999 P 30 motor home. Video on your site perhaps. Thank You

asked by: Dennis J

0

Expert Reply:

The Air Lift Air Spring Kit part # AL81560 that you referenced has been confirmed as a fit for your 1999 GMC P30 motorhome for the front axle. For the rear axle you would want the part # AL57203.

I attached a set of installation instructions for the part # AL57203, but for the # AL81560 I attached pictures of the install sheets for you to check out.

expert reply by: Jameson C

0

click to enlarge

Answer 1

For the front axle of your 2004 Workhorse P32 chassis the correct air bag kit is the Air Lift 1000 Air Helper Springs #AL81560. This includes both air springs and the hardware to install them. If you need just a single air bag by itself you can use…

view full answer...

Answer 2

There are definitely LED tail lights that will work to replace your Bargman 30-91-011//30-91-011, though there aren't any that are direct replacements. Based on my research, your current Bargman lights are about 8-1/2" long,…

view full answer...

Answer 3

The only replacement part available for the Hott Rod RV Water Heater Conversion Kit - Propane to Electric - 400 Watt - 6 Gallon #DGR6VP is the heating element #DGR6P2PB. Unfortunately, this means that the only option for a replacement cord with the…

view full answer...

Answer 4

We do indeed have just the heating element and wiring kits for Hott Rod Water Heaters available as separate parts. If you have a 6-gallon tank you will use part #DGR6P2PB for the element and for a 10 gallon tank we have part #DGR6P10PB. The correct…

view full answer...

Answer 5

I did some checking and the correct replacement panel for your Kwikee Level Best System is the part #LC77CJ.

view full answer...

Answer 6

The Lippert Replacement Power Gear Control Board for Kwikee Level Best Hydraulic Leveling System part #LC359289 will take care of the control board. I would start here. Generally this is what has failed. To verify look for a hot spot or a flash…

view full answer...

Answer 7

We've checked with Lippert in the past and they have told us that the Kwikee Level Best control panel can be replaced with the Lippert Control Panel part #LC77CJ.

view full answer...

Answer 8

The Replacement Lippert Components Control Panel with Amp Connector for 4-Point Leveling System Item #LC175225 will work for Lippert Components 4-point leveling systems like the Kwikee Level Best Hydraulic Leveling System #LC359275. For older…

view full answer...

Answer 9

The fittings on the bottom of the Air Lift bags like the part #AL81560 that you referenced do not have any type of valve in them so they can't be inflated directly. Basically it's a hollow fitting designed to have an air line slipped…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the…

view full answer...

Air Suspension Enhancement Recommendation for a 1999 GMC P30 Motorhome

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching