Replacement Roadmaster Diode Recommendation

Question

Question:

I need 3 diodes for a roadmaster tow dolly wiring kit. The kit they come from is their model 154. I believe they sell a 3 diode pack as part number 794 but Im not positive on that number. Can you help me? Thanks.

asked by: Michael F

0

Expert Reply:

Part number # RM-794 is for 4 diodes, so while it would work for you a better option would be to order a quantity of 3 of the part # RM-790 as that is a single diode.

expert reply by: Jameson C

0

Answer 1

Since your trailer uses a combined wiring system where the stop and turn signals run on the same circuit, in order to add a third brake light to your trailer you would need to use a 2-Wire to 3-Wire Converter, like part #118158. This will convert the…

view full answer...

Answer 2

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 3

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the AirLift 5000…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

When it comes to choosing between the Blue Ox Patriot #BLU37TR and the Brake Buddy Select 3 #HM39524, these systems are extremely similar in their setup and functionality. Both of these systems provide proportional braking in a compact and easy to…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

I would be happy to confirm the parts you referenced fit your 2019 Chevy Colorado and are compatible together. I have listed them below, along with any changes, and attached installation videos. Roadmaster Nighthawk All Terrain, Non-Binding Tow Bar…

view full answer...

Answer 8

There are a number of differences between the Firestone Ride-Rite Air Helper Springs #F2445 and Air Lift LoadLifter 5000 Ultimate Air Helper Springs #AL88299, starting with fit. While the Air Lift will fit all models of the 2018 Toyota Tundra, the…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

I would be happy to! To flat tow your 2024 GMC Canyon Denali you will need the following parts: Tow Bar and Safety Chains - Roadmaster Nighthawk All-Terrain Tow Bar w/ LED Lights item #RM-676 Base Plate Kit - Roadmaster Direct-Connect Base Plate Kit…

view full answer...

Answer 11

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 12

The Air Lift WirelessONE Compressor System #AL25980EZ and Air Lift WirelessONE Compressor System #AL25980 are nearly identical with only some very minor differences in CFM and duty cycle ratings. The #AL25980EZ will also come with an easier mounting…

view full answer...

Replacement Roadmaster Diode Recommendation

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching