Passenger Turn Signal Does Not Work and Brakes are Dim when Applied
Question:
Is this a ground problem? Or what could be the problem?
asked by: Danny
0
Expert Reply:
This does sounds like a ground issue. You will want to check on the trailer lights that the ground is secured to clean, bare metal. You might also want to check for corroded connections. Look for wires with worn or cracked insulation, or wires that are pinched or broken.
expert reply by:
Chris O
0
Product Page this Question was Asked From
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Parts Needed For Flat Towing a 2024 Ford Maverick Behind a 2010 Winnebago Journey With Air Brakes
- Q&A: Where is the Dummy Plug to Install a Brake Controller Adapter on 2019 Chevrolet Silverado 1500
- Q&A: Caliper Bolts for AL-KO/Hayes Disc Brake Caliper BP18-050
- Q&A: Does The Progressive Dynamics PD4655V Have A Lithium Jumper
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Which Instructions Are Used Installing a Roadmaster Brake-Lite Relay in a Ford F-150 w/ Neutral Tow
- Q&A: Recommended Diode for Charging Line From Motorhome to Towed Vehicle (Toad)
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Maintenance Schedule
- Q&A: How To Wire In The V-Shaped Identification Light Bar When Replacing Light With Only 1 Wire
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Trailer Tire Sizing