1,000 lb Jack Recommendation for Boat Trailer with 2 inch Pipe Mount
Question:
I have a problem, i need to replace my boat trailer jack but all jacks in my area are the same. The center hole on the mounting bracket is for a 2 inch hole, I need an 800 or 1000 lbs jack that has a hole of 2 1/2 inches. Does your company have any jacks with a center hole of that size?
asked by: Chuck T
Expert Reply:
The Bulldog Round, Pipe-Mount Swivel Jack - Sidewind - 15 inch Lift - 7,000 lbs, item # BD198250, has a male pipe on the jack and a female receiver that welds to the trailer. This female receiver has an inside diameter of just over 2-1/2 inches to fit on the 2-1/2 inch male pipe welded to the jack. This jack utilizes a 5/8 inch pin to secure the jack to the trailer.
For a jack with a 2 inch outside diameter male receiver that welds to the trailer frame and has a capacity of 5,000 pounds, we have the Bulldog Round, Pipe-Mount Swivel Jack - Sidewind - 15 inch Lift - 5,000 lbs, item # BD178203. This is the largest capacity jack we have with a 2 inch round mounting pipe. This jack also uses a 5/8 inch pin to secure the jack to the trailer.
Products Referenced in This Question
Bulldog Round, Pipe-Mount Swivel Jack - Sidewind - 15" Lift - 5,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 4001 - 5000 lbs
- Sidewind Jack
- Swivel Jack
- 15 Inch Lift
- Pipe Mount
- Weld-On
- With Rectangle Foot
- Bulldog
more information >
Bulldog Round, Pipe-Mount Swivel Jack - Sidewind - 15" Lift - 7,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 6001 - 7000 lbs
- Sidewind Jack
- Swivel Jack
- 15 Inch Lift
- Pipe Mount
- Weld-On
- With Rectangle Foot
- Bulldog
more information >
Continue Researching
- Q&A: Trailer Hitch Ball Wrench Size and Torque Rating for 1-1/4 Inch Hitch Ball Shank Size
- Shop: Erickson Eye Tie-Down Anchor for Boat Transom or Bow - Stainless Steel - Qty 1