Hitch and Brake Controller Recommendation for a 1998 Ford Van
Question:
Need a hitch to fit my 1998 E350 Four Winds motor home assuming it is same as E350 van but not sure. Does it double capacity of hitch when using weight distribution set up? Also need brake controller and 4 pin to 7 pin update can you shoot me what parts needed. Thanks,
asked by: Rob J
Expert Reply:
Since your van is an RV cutaway model then the only hitch that is going to work for a 1998 Ford E-350 RV cutaway model is a multi-fit motor home hitch like # 13703. I have included a link to the installation instructions for you to view.
This hitch is not rated for use with a weight distribution system. It has capacities of 3,500 lbs total trailer weight and 350 lbs tongue weight. Typically a WD system will increase the towing capacities for a vehicle, but it would not ever double them.
From there you would need to convert the 4-way to a 7-way so that you can install the brake controller. For that you will want the Brake Controller Install Kit and 7-Way Adapter part # ETBC7. I attached installation instructions and an install video for this product as well.
For a brake controller I would recommend the Prodigy P2 Brake Controller part # 90885. This is our best selling brake controller because of how well it works and how easy it is to setup.
Products Referenced in This Question
Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LED Display
- Up to 360 Degrees
- Tekonsha
more information >
Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
Product Page this Question was Asked From
Adjustable Width Trailer Hitch Receiver for RVs, 22" to 72" Wide
- RV and Camper Hitch
- Frame Mount Hitch
- 22 - 72 Inch Wide Frame
- 350 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Bolt-On
- Weld-On
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Will the Draw-Tite Trailer Hitch Fit a 2022 Volvo XC90 Recharge
- Article: Trailer Wiring Diagrams
- Q&A: Typical Trailer Suspension Hanger Spacing Relative to Leaf Spring Size
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Q&A: How To Connect A Dometic 310 RV Toilet To A Supply Line That's Too Far Away
- Q&A: Best Upgrade for Dometic 310 Part-Timer RV Toilet
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle
- Q&A: How To Activate 12V Trailer Charge Circuit On 2019 Ford Super Duty With Factory 7-Way
- Article: 2023 Best Gifts for Outdoor Enthusiasts
- Q&A: How Close Does Trailer Ball Height Need to be to the Height of the Trailer Coupler
- Article: How Harvest Hosts Is Becoming the New Standard of the Camping Industry
- Article: How to Replace or Install an RV Roof Vent