Locking Hitch Pin for a Blue Ox Alpha Tow Bar

Question

Question:

Were confused about whether our BX 7365 Alpha Tow Bar is a class II or class III which I guess we need to know to purchase a lock. We also bought a receiver which will need a lock as well.

asked by: Connie M

0

Expert Reply:

The Blue Ox Alpha tow bar, # BX7380, and all hitch mounted tow bars fit in a 2 inch receiver. So you would need a 5/8 inch diameter lock such as # BX8858. A Class II accessory would have a 1-1/4 inch shank whereas Class III accessories have 2 inch shanks.

expert reply by: Michael H

0

Answer 1

Blue Ox makes a great hitch lock with the part number #BX8858 but another really great option is the Blue Ox Base Plate and Hitch Lock set part #BX88101 which comes with locks for the base plate to the tow bar as well as the tow bar to the hitch…

view full answer...

Answer 2

I have never seen a connection like that for a 4-way. Regardless of the pin size the slot is internal to the plug on the connection point instead of external as on current 4-Pole Round Connector #PK11404. I recommend replacing the connection with a…

view full answer...

Answer 3

I went out to the warehouse and pulled a similar part, #RM-910030, to take some measurements. The only difference is that the part I measured is a flat piece and does not have that lip at the top. The center holes are exactly the same. I took…

view full answer...

Answer 4

For replacement Blue Ox Base Plate tabs we have the following: Tab Assemblies for Blue Ox Baseplates - Short Front/Short Back - #BLU57XR Tab Assembly for Blue Ox Baseplates - Short Front/Long Back - #BLU37XR Tab Assemblies for Blue Ox Baseplates -…

view full answer...

Answer 5

Hi Chris; your 2022 Ford Expedition will have a Normally Closed application, and it is possible when installing the Roadmaster Brake-Lite Relay Kit #RM-88400 that you'll need Hy-Power Diode #RM-790. I can't say for sure because…

view full answer...

Answer 6

The EcoHitch Stealth Trailer Hitch Receiver #TL84CR sits right on the edge of the fascia so you would likely not need to trim it at all but may have to trim just a tiny bit under the vehicle right at the receiver tube if it fights you when you try to…

view full answer...

Answer 7

For a made in the USA aluminum ball mount we only have adjustable units like the Flash Secure 2-Ball Mount #DTSTBM6600-2S which includes stainless steel hitch balls as well. The Fulton #F97CR you found as well as the similar Curt #C74WR and Brophy…

view full answer...

Answer 8

The Blue Ox Trailer Hitch Receiver Lock, part #BX8858 is only available with one lock in a package. They do not have the Keyed-alike option. When ordering this lock you can change the quantity in your cart to add the second lock.

view full answer...

Answer 9

I attached a picture that has all of the dimensions of the Curt trailer hitch part #13573 that you referenced. I also attached an install video for you to check out as well.

view full answer...

Answer 10

We can get your 2022 Ford Expedition set up to be flat towed behind your Prevost motorhome with air brakes, and there are a number of parts you'll need, which I'll go ahead and list out for you below. The only thing to note is that there are…

view full answer...

Answer 11

Yes, we do. I have attached them below. This hitch is confirmed to fit the 1985 Chevrolet C/K Series Pickup with the 6' or 8' beds with a standard or step bumper and the cab and chassis models.

view full answer...

Locking Hitch Pin for a Blue Ox Alpha Tow Bar

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching