What Stabilizers do the # UF19-950002 and # UF19-950202 Fit

Question

Question:

Im looking to purchase the tripod stabilizer #UF19-950500. Is one of the extensions you advertise UF19-950002 or UF19-950202 compatible with this stabilizer? Asking as my trailer kingpin starts at 53 inches as measured from ground to plate when level. Im concerned that I may need the extensions if the ground is not actually level. Keystone Hideout 282 RKS 5th wheel. 1495# hitch weight, 10300# gross.

asked by: Ben S

1

Helpful Expert Reply:

The extension pieces you referenced, part # UF19-950002 and # UF19-950202 do no fit the # UF19-950500 that you also referenced.

The # UF19-950002 is designed to fit the # UF19-950001, and the # UF19-950202 is designed to fit the # UF19-950200.

expert reply by: Jameson C

1

Answer 1

Ultra-Fab 5th Wheel King Pin Tripod Stabilizer #UF19-950001 has a height range of 37 inches to 50 inches and a capacity of 5,000 pounds. The distance from the ground to the pin box skid plate where the king pin is attached would need to by within the…

view full answer...

Answer 2

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Hey Joe, yes the Lippert stabilizer jack part #LC298707 does fit your Grand Design Transcend 245RL but it is sold individually so if you wanted a set for the front and the rear you would need to order a quantity of two.

view full answer...

Answer 5

I am sorry but we do not have an AC cover with those dimensions. The closest option we have is the Replacement RV Air Conditioner Cover for Penguin and Dometic Air Conditioners item #AT3308046006 which measures 40-1/2" long x 29" wide x…

view full answer...

Answer 6

Hey Tim, thanks for reaching out! The Stromberg Carlson Base Pad Extreme for RVs and Trailers #SC33VR have a 6,000 lb rating for each Base Pad Extreme so you're looking at a total of 36,000 lbs for this kit of 6. Ideally your jacks will have the…

view full answer...

Answer 7

The Clearsource Ultra RV Water Filter System w/ VirusGuard #CS87FR weighs 34.125 lbs.

view full answer...

Answer 8

If you have the Gooseneck versions of the Curt CrossWing ( #C92DR or #C32DR) you unfortunately would not be able to use the Rota-Flex with it. The pivoting head causing too much strain for the single point of contact you have with a gooseneck hitch.…

view full answer...

Answer 9

We have the following Gen-Y shock absorbing 5th wheel pin boxes which are compatible with the Lippert Rhino pin box bolt pattern. The weights listed below are the maximum capacities the pin box is capable of supporting. 21,000 lbs - 3.5K TW #GY86GR…

view full answer...

What Stabilizers do the # UF19-950002 and # UF19-950202 Fit

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching