10 Hole Thule Bike Rack Strap Recommendation

Question

Question:

Need strap longer than the stock one with 8-holes - Replacement Strap for Thule Bike Racks with Stay-Put Cradles - 853-5834. Really need 10-holes.

asked by: Allen

1

Helpful Expert Reply:

I believe I have a solution for you, but my contact at Thule strongly recommended you only use the recommended strap for your bike rack, and not try and use one designed for a different rack.

That being said the part # 853-7803 is 9 inches long and has 10 holes.

expert reply by: Jameson C

1

Answer 1

The 1" x 9" cradle strap on your Jack-It 2 Bike Rack for A-Frame Trailers LC429756 are the longest straps offered. However, we do also offer the Replacement Straps for Cradles on Curt Standard and Premium Bike Racks #C18007, and the…

view full answer...

Answer 2

Thanks for reaching out! The Rola NV2 Hitch Mounted 2 Bike Rack (part 59508) was discontinued a number of years ago and while we used to carry replacement cradles and straps as part 59514, those are no longer available as well but I may still have a…

view full answer...

Answer 3

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 4

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 5

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 6

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 7

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Answer 8

To see all of the correct wheel and tire combos you'd need check out the link I attached. The option I would recommend is the part #TA43RR which is a Load Range C tire size ST175/80R13 mounted on a white spoke wheel with a bolt pattern of 5 on…

view full answer...

Answer 9

I have a solution for you, but we do not carry Glo-Brite lights, so replacing it with the same brand will not be something I can offer you. Instead, to replace your Glo-Brite 9852-88, I recommend using the Optronics LED Trailer Tail Light #STL72RB.…

view full answer...

Answer 10

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 11

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 12

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

10 Hole Thule Bike Rack Strap Recommendation

Product Page this Question was Asked From

Continue Researching