Replacement Rail Corners for Extang Black Max Snap-On Tonneau Cover

Question

Question:

are these for the rails with the snaps?

asked by: Joe M

0

Expert Reply:

You are correct. These replacement corners are for the Extang Black Max, which is a traditional style Tonneau cover that uses side rails that attach to the top of the bed sides. Instead of hook and loop fastener, snaps are used to hold the tonneau cover in place to the side rails. Part # EX4205-2 provides 4 replacement corners for the Black Max Tonneau Cover.

expert reply by: Mike L

0

Answer 1

Correct. These replacement corners are for the Extang Black Max, which is a traditional style Tonneau cover which uses side rails that attach to the top of the bed sides. Instead of hook and loop fasteners, snaps are used to hold the tonneau cover in…

view full answer...

Answer 2

I spoke to my contact at Extang and he said it sounds like you have a Black Max tonneau cover and the correct side rail connector that you would need is the part #EX4205-2 that you referenced and then for the replacement sliding clips you would want…

view full answer...

Answer 3

I checked with Extang to try and get more instructions on how the corner pieces of the Trifecta are held together and this is what they sent me: The corner pieces of the trifecta are held together, then the inside corner brace assembly is screwed in.…

view full answer...

Answer 4

Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb capacity,…

view full answer...

Answer 5

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 6

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 7

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

The length of wire desired depends on your vehicle connection and your personal preference. You want enough slack for turning, but not so much for dragging as you mentioned. A little extra slack isn't a problem and not enough could lead to stress…

view full answer...

Answer 10

The correct replacement master cylinder kit we have for your Demco setup is the part #DM5918 which comes with the lock out replacement.

view full answer...

Answer 11

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 12

Below is the general process for bleeding an electric over hydraulic brake actuator like #K71-650. Fill reservoir with NEW brake fluid. Never re-use brake fluid that has been salvaged or removed from another system. Remove the key from the breakaway…

view full answer...

Replacement Rail Corners for Extang Black Max Snap-On Tonneau Cover

Product Page this Question was Asked From

Continue Researching