There is a intermittent outage and I can't figure it out. The problem occurs at start-up (when vehicle is turned on) and lasts about 5-10 minutes then lights on trailer come on. It happens about 20% of time. If you are traveling at night, this is a real problem. Also, the vehicle displays that a device that is draining the battery and when I disconnect the power to the module the message stops. I like the ZCI but I wonder with the vehicles multiplexing signals for lights could be the culprit.

Mounting screws are rusting

Ordered hitch receiver with wiring for bike rack installation on 2019 Ford Explorer. Everything arrived in less than a week. Crawled under the car with my burly son and finished the installation in about an hour. Toughest part was getting the exhaust hangers off. Didn't have a tool for that. Online installation video was a big help. Hitch frame rubs against right side exhaust hanger, hence the four star rating instead of five. Exhaust still appears to be level and no weird noises, so not an issue. Get the little plug in light tester. It's worth it, then keep it in the glove box. Haven't purchased bike rack yet, but no concerns about the hitch.

I installed the draw tite hitch onto my brand new 2018 Subaru outback. I'm 68 years old, not as strong as I was, but proud to say I did the job all by myself in about 4 hours. Here are some tips you may find useful. Watch the video-it’s pretty good. I had difficulty getting the exhaust system down and worried about getting it up again from the moment I got it down...read on-help will follow. I bought a stepup drill bit which worked great for drilling the hole in the chasis. I clamped the hitch onto a floor jack, then rolled it and raised it into position. Used metal shears to easily cut out the heat shield as per the video. Your inclination will be the screw the fishing tool provided all the way up the carriage bolt. That won’t work; just screw it on to the tip of the bolt. I couln’t get the exhaust hangars in place even after lubricating them with wd-40. I dropped the rubber hangars into undiluted liquid car wash soap which made them much more slippery than the wd-40. After that the rubber hangars slipped into place pretty easily-that’s my best tip. Finding the electric connection plug for the wiring harness was almost as hard as installing the hitch. I was very happy with how the job came out. Good luck.