Part Numbers: SB324-172,31108
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Hitch-mounted snowplow makes short work of your snowy driveway or parking lot. Pivoting, 5-position blade glides over uneven ground. Long-lasting actuator with internal clutch lets you operate plow from your warm cab.
Features:
Specs:
Note: Due to the size of this item it ships via truck freight.
The SnowBear Proshovel conveniently slides into your vehicle's front-mounted trailer hitch for easy, convenient mounting. Smoothly and easily raise and lower the plow from the comfort of your cab with the remote-controlled electric actuator. The pivoting blade makes this plow ideal for rocky or uneven surfaces because it can adjust to the terrain. Angled trip springs are also built in to help keep the blade from catching and tripping. Being just 39" away from the bumper, the Proshovel snowplow has a compact yet strong and sturdy design.
Simple, Hitch-Mounted Installation
This hitch-mounted snowplow simply slides into your vehicle's front trailer hitch receiver, making it a breeze to install. Unlike a plow that attaches to custom-fit brackets, which ties you down to just 1 vehicle, this hitch-mounted plow can be used on most trucks or SUVs with a 2" x 2" front-mounted hitch. As a result, this plow can be easily switched between multiple vehicles. And because it offers a nearly universal fit, you won't have to buy a new plow when you replace your old vehicle.
To install the Proshovel snowplow, just slide the shank of the plow assembly into your 2" trailer hitch receiver . Then use a pin and clip or a hitch lock (sold separately) to secure the plow in the receiver.
How to Plow
Once the plow is mounted on your vehicle, lower the blade and set it to the desired angle. To set the angle, exit the vehicle and manually position the plow straight ahead, 11 degrees to the left or to the right, or 22 degrees to the left or to the right. Angling the blade allows you to push snow off to the side where you want it without having to change the angle of your entire vehicle. This is especially useful on a driveway or private roadway where piling the snow straight ahead would create a barrier.
To begin plowing, just drive forward. When backing up to take another pass, be sure to lift the plow with the remote or the in-cab toggle switch, then lower it again before moving forward. When approaching a large pile of snow, be sure to decrease your speed. Slamming into a pile of snow can void the warranty on the Proshovel.
When you are finished, put your vehicle in park and lower the plow. Remove the plow from your vehicle after every use.
Smooth, Controlled Lifting with Electric Actuator
The electric actuator on this plow allows you to lift and lower the blade using a toggle switch that mounts in your cab. You can also use the included wireless remote control. To raise the plow, activate the actuator. As the actuator moves along the internal screw, the arm on top of the actuator will pivot, raising the plow blade by pulling the chain that is attached to it. Having fewer moving parts than a typical winch makes this setup less complicated and less likely to break down than other plow lifting and lowering devices. There is also an internal clutch system that prevents damage to the actuator should you try to raise the blade too high or lower it too low.
Add-On Accessories
SnowBear offers a plethora of helpful accessories to make plowing even safer and easier. Along with the available accessories to enhance your snowplowing experience, many parts of the SnowBear Proshovel snowplow are available separately, so you can replace worn-out pieces without having to replace the whole plow.
The off-road halogen light kit (SB324-127) may be necessary if your plow blocks your vehicle's headlights. This kit will light up the way when you're plowing at night or in the early morning. The light kit mounts directly to your plow frame and offers increased visibility when plowing in dark conditions. The 2 bright halogen lights make it easier for you to see where you are going and for others to see you.
With the caster kit (SB324-126), it will be a breeze to move and store the Proshovel snowplow when it's not in use. These wheels mount directly behind the blade and they can be easily folded down for use and up for storage. In addition, these wheels will not weigh the plow down.
The drop extension kit (SB324-128) allows you to use your SnowBear snowplow on your lifted vehicle. With 6" of drop, this bolt-on kit ensures that the plow makes proper contact with the ground. Its sturdy steel construction is just as strong and durable as the plow itself.
If you are worried about causing damage to your lawn or pathway, the poly scraper attachment (SB324-069) is perfect for replacing the harsh, steel scraper on the Proshovel. The polymer construction is strong enough to still help plow efficiently, but gentle enough to not hurt your lawn or pathway.
Easily attach a variety of accessories to the front of your vehicle with this fully welded, corrosion-resistant trailer hitch receiver. Perfect for winches, spare tire carriers and more.
Features:
Specs:
At etrailer.com we're committed to the products we sell, and to our customers. Our experienced and knowledgeable staff are available via both phone and email to address your questions and concerns for the lifetime of your hitch. The technicians at etrailer perform hitch installations on a daily basis, making them a valuable resource for do-it-yourselfers. The one-on-one, personal service you'll receive comes straight from an expert in the towing and automotive field. We've installed it, we've wired it and we've towed with it, so whatever your question, we can answer it.
Average Customer Rating: 4.8 out of 5 stars (117 Customer Reviews)
Hitch-mounted snowplow makes short work of your snowy driveway or parking lot. Pivoting, 5-position blade glides over uneven ground. Long-lasting actuator with internal clutch lets you operate plow from your warm cab. Easily attach a variety of accessories to the front of your vehicle with this fully welded, corrosion-resistant trailer hitch receiver. Perfect for winches, spare tire carriers and more.I had been waiting to find this Curt hitch on sale for a while.
First off I get to keep the hooks that came with my 2004 Silverado Crew cab 2500HD 4x4.
Then I removed two existing bolts and loosened a third on each hook.
Using a floor jack lifted the hitch into place and threaded in the new bolts through the frame and into the hooks.
The biggest problem I had was being able to reach the bolts into the side of the frame and hooks w/out removing the air dam.
Looks GREAT!!
I know some reviews have mentioned a reduction in ground clearance but my truck is not lifted and the clearance is nearly the same as the transmission skid plate installed by the factory.
I sometimes need to get low hard to see trailers into tight spaces and I’m also looking to pick up a winch. Looking forward to many years of hard work.
Unbelievable how clean the install is for this product!! I was certain I would have to do some cutting or drilling, however not a single cut or new hole required. The product fit like it was straight from the factory ... even with the existing front Grille Guard that I have on my truck!!
I also appreciate the FAST shipping and customer service, as tracking info was emailed after the product shipped without requesting this info and the product arrived within the same week.
I've already recommended etrailer to other landscapers on lawnsite.com, as we're always looking for front-mount solutions for spreaders and other landscape equipment.
Dale M.
1/28/2015
I have to say that I absolutely LOVE this product!! It works perfect for mounting my walk-behind fertilizer spreader to the front of my truck while having the larger PermaGreen spreader on the back of my truck. Having this front-mounted hitch has allowed me to carry both of my spreaders and not sprain my back while wrestling the smaller spreader out of the bed of my truck as I had before.
Overall it's a good light duty plow, works like it's supposed to, clears the snow with no problems. Originally purchased the plow with the hitch receiver mount, But the plow stuck out quite a bit in my opinion plus there was to much wobble. So I converted to the 2 point mount which brought the plow in closer and a lot less wobble.
There was an issue with the actuator, it would work intermittently when lowering the plow but Snow Bear covered it under warranty and sent me a new one.
My only gripe is that only after 3 months of Winter use, the whole plow was showing a lot of surface rust and the paint was peeling.
This was the easiest installation of the 10 or more hitches that I have installed. Four bolts out and replaced with four suppler bolts and washer. No modification of the air dam needed.
I needed some washers (supplied) between the frame and the receiver as spacers. I recommended that you figure out how many you need (1 or 2 per side), then lower it down and tape them in place to hold them in place and push the bolts through the tape after you lift it back in place.
Cover the ground with a rug or cardboard to keep from scratching the receiver when it’s on the ground before you lift it into place.
Matthew
5/11/2021
Still good. No corrosion or other issues.
This was possibly the easiest hitch install I've ever done! All the holes lined up, the onle thing was two of the bolts they supplied are not long enough,I had the longer bolts in stock and finished. I haul a truck camper so needed the extra cargo space, looks like it'll work!
there was 4 bolts in the kit to replace the bolts in the tow hooks, the 2 that went into the side where the ones that where too short, they where 1 3/4" I replaced them with 2 1/4" bolts. There was a gap between the hitch mount and the frame approximately 1/16" that a washer filled that gap. I'm a retired shop owner that did auto repair and fabrication so it was an easy install.
Jenny N.
11/8/2021
I will have our customer service team reach out to you. The hitch manufacturer prefers to have the hardware that comes with the hitch be used for warranty purposes.
I purchased the front hitch for my truck. With a fifth wheel I can’t carry bikes anywhere but the front. I really don’t trust the strength of the rear bumper on these RV’s. Hitch went on easy in the garage with no alterations needed. The bikes sit a bit high but that’s not the hitch problem....
I will also use it for other functions around the truck...push/re-locate utility trailer in tight spaces, use for a rack to haul stuff like firewood etc...when back hitch is unavailable.
Overall it is a good setup, does the job it's suppose to. Had one problem with the actuator intermittently working when lowering the plow, but was replaced under warranty.
Originally purchased to use in a front mounted hitch receiver, but switched to the two point hookup which brought the plow in closer to the vehicle and made it a little more stable.
My only problem was after 3 months of winter use, paint was peeling and a lot of surface rust showing.
Easy install; unobtrusive, but hitch receiver is far enough forward I can install the bike rack without needing an extension.
Great product easy installation reinforces your front end will definitely buy again for my next truck
This is the second hitch I've ordered for my truck. This hitch was very easy to install on the front of my GMC Sierra and is almost unnoticeable, which I like. I use it to transport a small Honda Trail 90 motorcycle, and it's 9000lb rating is well above what I am asking it to do. It arrived via UPS several days after ordering, was in good shape, and only took ten minutes to install with only two different size socket wrenches. Highly recommend this unit for the front of any truck.
The 31108 Front Mount Hitch Receiver was a perfect match for my 2004 GMC Sierra 3500. I seemed well built and the instructions were clear and easy to understand. I installed the hitch in under 45 minutes and that includes prep time. No special tools required. See photo attached.
This fit my 2006 Silverdo 3500 easily - and it has been a great addition to be able to carry my motorcycle in front of the pickup while camping.
I waited 12 days for a shipment from amazon and the hitch was lost. They want to send me another hitch with a due date of January 6, 2024! You guys are the best! 2 day’s service was outstanding!!!
I would add to your instruction, if you have the factory hooks, remove the four bolts as stated and give to customer, " loosen the other two bolts on the outside of frame" this gives you a little wiggle room to start the new bolts. BUT great product and great people.
Fit great lineup no modifications happy with the results
Alfred
1/31/2024
Wonderful very satisfied with the sales department and the quality of the product
This hitch mounted to tow hooks just as described, even with existing brush guard. Needed it to haul a generator the only issue was the brush guard stuck out too far so I had to buy a 12" extender. Now every thing works as planned. Shipping was fast and customer service was great.
Thank You
Very good quality, Heavy Duty hitch that looks easy to install.
Ian W was very helpful with my order and customer service has been great.
This hitch fits the Chevy Silverado 2500 and 3500 I believe. My Chevy is a 2006 model.
I highly recommend Curt hitches and ETRAILER.COM.
Brian
Brian
2/26/2020
The front hitch was easy to install and has been very useful. I just wished the 2006 Chevy Silverado had more clearance as far as height goes on the front end.Mine is a 4x4 but it could sure use a lift kit. The hitch is great though!
You sent me the wrong part.
15 minute, piece of cake single-handed install. Instructions say cutting fascia optional on 2500. Not even close to needing to. Truck is 2005 Silverado 2500HD. Receiver sits up there nice and tight, so doesn't change ground clearances.
Hitch is in excellent condition even though it tried to get out of the box.
Front hitch for 2005 Chevy 2500hd that I ordered from etrailer.com
Repetitively easy to Mount and was still able to keep the factory toe hooks installed
I did not get a chance to put it on right away. Now that I have put the front hitch on , it looks great. It was harder getting the original old bolts off than it was putting on the hitch. The hitch went on quickly and now I can use it to put a plow on for these snowy Ohio winters.
I received the product (hitch) today and haven't had the opportunity to put it on my truck. I hope to do that this week or next. I can write an additional review at that time. Wayne H. did a great job clarifying which hitch would be best for my needs. I'll summit a picture after it is installed.
Andy G.
1/13/2016
I love the product. It has come in lhandy many times when moving my trailer and boats. I would definitely purchase another if I ever purchase another truck in the future. I would recommend this product to anyone.
Easy install, the bolts that went into the recovery hooks were about 1/2” short and couldn’t get the threads to bite
Ask the Experts about this Snow Plow
Do you have a question about this Snow Plow?
Info for these parts were:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
John
3/31/2021
This has made getting trailers parked closely and out of the way at job sites so much easier. Whish I hed it years ago!