It is really not a great idea to drive with a trailer cover like the part #052963735635 installed on a trailer. The only way I could safely recommend you do so is if you were to keep the speeds under 25 miles per hour and you weren't on a…

Most likely the new axle has self-adjusting brakes which when new are known for feeling pretty weak. The good news is that you can keep applying them over and over while the trailer is traveling and they will tighten and get more sensitive feeling.

Actually on brake magnets for trailers either wire can be used as the power or the ground so the colors don't really mean anything. Most likely the magnet manufacturer just put what ever color was most convenient on your trailer.

I would check the magnets for wear before going on to test them with a meter. If the magnets show abnormal wear or if you can see the windings beginning to show through the friction surface of the magnet then they will need to be replaced. To further…

Brake magnets are made to fit their specific brake assemblies. They are not made to be interchangeable between brake sizes or weight capacities. Some manufacturers do use different color magnet wires that correspond to the capacity. We know that…

With an unkown axle it is hard to know what it's capacity would be. Plus a trailer's capacity is more than just the axles it uses. You have to consider the suspension, the frame, coupler, brakes etc. The part #20440I-EZ-60 that you referenced…

There are and were numerous 2-step Kwikee electric steps available. To ensure we get you the correct replacement I would need to know the series of the steps you have. Check the underside of your steps for any model numbers or other information. The…

The most similar trailer clearance lights we offer to replace the PM150 lights you have now would be the Thinline LED light part #AL91RB. For a replacement harness that would plug into this you'd need the part #A46PB and then for a grmmet part…

The part number you gave is no longer a valid number for Bulldog jacks. It sounds like you are looking for the Bulldog Square Jack w/ Footplate - Drop Leg - Sidewind - 15" Lift - 5,000 lbs #BD190754. This has a 5,000 lb lift capacity and an…

Hey Philip so while we don't carry the exact spring you are looking for it does match the specs of the #e59SR so this would be a great solution. It's correct length at 23-1/8 inches and is for a 3,500 lb trailer axle like you have as well.

The B&W Continuum #BW78FR and the Reese Strait-Line #RP66083 are both great systems. The B&W Continuum is going to be easier to set up, but as far as sway control goes, I definitely have to give the edge to the Reese Strait-Line. The…

One solution that seems to work well with the factory hitches of the 2017 Chevy Silverado 2500 would be shackles like the #358smallshackle which you'd attach to the loop on your hitch and then attach the safety chains to.