Videos
for Safety Supplies
Help Articles
for Safety Supplies
Expert Answers
for Safety Supplies
I reached out to Lippert and they informed me that the Replacement Pneumatic Hose #LC28AF is the same as the CPU00002 from your manual. This is the correct replacement line for your Lippert Center Point #LC1565391. The system has mechanical bag…
view full answer...According to Dexter, the nut should be torqued to between 45-70 foot lbs. If you don't have a torque wrench close at hand, Tighten the bolts until the lock washer flattens, which will put you really close to the correct torque. We offer 4…
view full answer...Yes, there are a couple of different 5th wheel hitches available for the 2024 GMC Sierra 3500 with the factory puck system depending on what length bed you're getting. If you are getting the shorter 6-3/4' bed you will need a sliding…
view full answer...The brake mounting bolt pattern for the #84 E-Z Lube Spindle w/ Brake Flange for 3,500-lb Trailer Axles #TRU87FR is 2-13/16" and then the section that fits into the axle tube is 2" and it tapers out to 2-3/8". Attached are dimensional…
view full answer...When using a single set of tire chains on a vehicle that is 4 wheel drive or all wheel drive you want to install the chains on the primary drive axle. Typically this will be listed in the owner's manual. But for a 4WD drive vehicle the axle to…
view full answer...Some newer cars, vans and small trucks, especially those with large, aftermarket tires, may require the use of Class S chains. Class S tire chains are designed for use on vehicles with restricted wheel well clearance. I have attached a photo that…
view full answer...The TruRyde Spindle Nut #165686 has an outer measurement of 1.45 inches. You will use a 1-1/2 inch socket on this castle nut or we usually use a channel lock for these installations. I've attached a video of an installation of a hub to assist.…
view full answer...Titan Chain Snow Tire Chains #TC2828CAM have a device to hold the excess chain. If you wanted to remove a few links you could do so but be careful because there may come a time when you need that extra slack since not all tires of the same size are…
view full answer...Yes, the puck system used on the 2016-2019 Chevy/GMC trucks is different than the pucks used on the 2020 and newer trucks. So you would need a 5th wheel like the B&W Companion #BWRVK3710 for your 2020 GMC Sierra 3500 with an 8' Bed. If you…
view full answer...The correct grease cap for the Dexter Trailer Hub and Drum Assembly for 8,000-lb E-Z Lube Axles #DX46XR is the #TRU66FR.
view full answer...With plywood walls that are as thin as yours, it's possible that they may not support what you are looking to do. The only way you will be able to utilize the Erickson Horizontal E-Track #EM59150 (2 feet) or #E19148 (5 feet) is by installing it…
view full answer...If you need 18 feet of E-track I recommend using 2 pieces of 8 feet Horizontal E-track part #E19135 and 1 piece of 2 feet E-Track part #EM59150. 8 feet is the longest Horizontal E-Track available. The E-track pieces are not designed to be mounted…
view full answer...