Filter Products
Filter by Type of Camera
$479.99 - $479.99
Videos
for RV Camera System
Help Articles
for RV Camera System
Expert Answers
for RV Camera System
The correct replacement master cylinder kit we have for your Demco setup is the part #DM5918 which comes with the lock out replacement.
view full answer...A #93 incandescent bulb has a single contact bayonet base, and there are a couple of options for LED bulbs that will replace these. You can choose a bulb that gives off either a warm or cool light; I have added a photo showing the difference…
view full answer...You would not be able to charge your battery through the wiring on your 4-way trailer connector. Since your truck has a 7-way connector, you could maintain the power to the battery but not charge it. To begin, you would need to cut off your 4-way…
view full answer...To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…
view full answer...You do not want to use a holding tank heater like ThermaHeat #277-000164 on a battery but we do offer battery heaters specifically intended to protect one from extreme cold. You can see all such items on the page I linked for you. You'll want…
view full answer...From the looks of the photo you sent it does not look like you have an OEM suspension system on your boat trailer. I recommend securing the suspension rail to the trailer frame in a more secure manner like drilling and using bolts so that it does not…
view full answer...We do carry a repair kit for the Dutton-Lainson DL-1602A trailer winch. You can use Winch Ratchet Repair Kit, #DL70455, as long as your winch was made after 1999. This kit will also fit DL1402A and DL1602ADD made after 1999.
view full answer...Unfortunately there are no plug-in adapters or harnesses that would allow you to replace the factory 4-way flat trailer connector with a 7-way or a 7-way and 4-way connector on your 2005 Ford F-150. To complete the installation for a brake controller…
view full answer...The Bargman LED, Recessed, Double Taillight #47-84-527 is designed to go on either the left or the right side of your trailer. You would wire it up to the trailer wiring by function. So, if you were installing this on the driver side of your trailer…
view full answer...The UFP H-1377 correlates to a Dexter #84 spindle, which is for a 3,500 pound axle. This will utilize an inner bearing #L68149 and an outer bearing #L44649. As this is being used on a boat trailer, I highly suggest going with the etrailer.com…
view full answer...The best way to test this out is by applying 12V power to the motor directly so you can see if it operates correctly outside of the control module (see attached). If everything works properly when you've bypassed the control module then…
view full answer...It sounds like when the Redarc Tow-Pro Elite Brake Controller #RED44FR was installed on your 2022 Toyota Highlander that they may have damaged the brake signal wire or tied into the wrong wire. I recommend taking it either back to the shop who…
view full answer...