Filter Products
Filter by Application
$75.00 - $99.00
Videos
for Cup Holder
Help Articles
for Cup Holder
Expert Answers
for Cup Holder
Hey Eric, the Curt Multi-Fit Ball Kit w/ 4" Offset for Chevy/Ford/GMC/Nissan Underbed Gooseneck Hitch #C68ZV is not going to work with your Ram, unfortunately. This one is only going to work for select YMM (Year Make Model) Ford 250-450s,…
view full answer...You're likely correct that this issue is with the truck, and I know that with the first generation of the factory integrated brake controllers on the Ram trucks there were a lot of issues like this that people have seen. You also mentioned…
view full answer...Looks like you have slipper springs on your 2001 Coleman Utah pop up. We have replacement slipper springs available like the #e29SR which is 30 inches long and for 1,800 lb axles or the #SP-179275 which is 24-5/8 inches long and for 2,000 lb axles.…
view full answer...The replacement reverse lock out you are looking for is the part #TK71-755-00. This would allow you to use the same adapters and fittings you have now.
view full answer...The Blue Ox has a life expectancy of 8-10 years, Blue Ox does recommend replacing it at this point. There are a few big differences between the Roadmaster Nighthawk All Terrain, Non-Binding Tow Bar w/ LED Lights - RV Mount - 8K #RM-676 and the Blue…
view full answer...The axle U-bolt torque spec will depend on the bolt diameter- • 5/16 inch- 65 ft/lbs • 1/2 inch- 45-70 ft/lbs • 9/16 inch- 65-90 ft/lbs • 5/8 inch-100-120 ft/lbs • 3/4 inch-160 ft/lbs Shackle bolts don't typically have a specific torque value.…
view full answer...The cupholder portion of the Optronics #2409171B is adjustable between roughty 2-1/2" and 3-3/4" so this would be a good fit for you if you're referring to the beverage holder dimensions. The casing dimensions on this cup holder are…
view full answer...You will need to measure the diameter of the spindles where the seal and bearings ride. Check out the picture I attached that shows where this is. You will need an exact measurement so either a digital or dial caliper will be needed. To pick out the…
view full answer...Yes, you will need to use the Wedge Block #LC79UD for the Lippert Turning Point pin box on your Grand Design 5th wheel RV camper. This is a universal block that will fit into the funnel on the B&W Patriot 5th Wheel Trailer Hitch #BWRVK3255 and…
view full answer...The correct height setting is going to vary by trailer but you can get there taking some measurements. First make sure your trailer is on level ground and then measure from the ground up to the bottom of the king pin. Then on your truck take a…
view full answer...The B&W Companion Slider #BWRVK3775 is really hard to argue with as being the best sliding 5th wheel hitch for your 2022 GMC Sierra 2500 with the puck system. Not only is it a great hitch when it comes to quality, but it also has the mounting…
view full answer...The side of the shackles with two holes needs to be mounted on the bottom of the Lippert Center Point item #LC1565391. The side with the single hole connects to your leaf springs. I have linked an installation video below along with a couple of…
view full answer...