Thanks for reaching out, Michael! The Dexter Electric Trailer Brakes #K23-086-087-00 are compatible with 3,500 lb axles and have the standard 4-bolt pattern so if that matches the specs of your axle then this will definitely work for your…

Sorry for the confusion, our part number #IN87RR is the same as Inno's BRP820 which does fit the Inno Wedge cargo box you referenced.

Hi Shelly, thanks for the question and it's possible we have something depending on the dimensions of your skylight/sunroof. What most people use for this is the Camco Lights Out Retractable Shade for RV Roof Vents…

Yes, the Voyager WiSight 2.0 Wireless RV Backup Camera #ASA84YR will have consistent signal with your setup. The camera and monitor both have a wireless range of 60 feet or more. So even with about 52' between them, you…

The Easy Grease Trailer Idler Hub Assembly for 3.5K Axles part #AKIHUB-545-35-G-EZ-K is a direct replacement for a UFP H-1377.

The Replacement Clamp #RRSP112 is a single clamp for the Rhino-Rack Roof Mounted Steel Cargo Basket #RMCB. Included is the clamp, screws, and all parts to secure the basket at one point to your crossbar.

That's quite a large gap between the top plate of the hitch and the pin box surface. That to to me would indicate there's a problem. Most likely it's a high pinned…

Thank you for all of the info you gave. Based on that you'd want the trailer hub and drum part #AKHD-545-35-K that you referenced and then for brake assemblies to match you'd want the…

You are going to want either our Bearing Kit #BK2-100 or the Timken Kit #TMK52VR. Both of these kits will give you the inner/outer bearings and races along with a grease seal and cotter pin/D-washer for one hub. You always want to replace the race…

Yes, the red wires of the Progressive Dynamics RV Power Control Center with AC/DC Panel and Converter/Smart Charger - 35 Amp #PD4135K are going to be labeled with a 3-digit code with 001 being the wire for your battery's…

The rubber pads for the Rhino-Rack XTray Clamp Set unfortunately are not sold separately so you would either need to reach out to Rhino-Rack to see if they could ship you them or purchase a replacement clamp set #RRSP112.

I have a solution for you, but the Optronics LED RV Exterior Scene Light #UCL41CB is designed to work on 12v power only, so it's not going to work on a 110v/120v feed. Unfortunately all of the lights…