bing tracking image

Filter Questions and Answers:

reset filter

Expert Answers about Infiniti


  • How Many Handles Are on The DeeZee Specialty Series Underbody Toolbox # DZ76
  • I checked with my contact at DeeZee and the Specialty Series Underbody Toolbox # DZ76 that you referenced has two handles, one on each of the shorter sides. This rustproof Brite-Tread aluminum tool box features a locking stainless steel T-handle latch and two keys and a water-tight C-channel seal to protect your belongings. It is USA-made and carries a limited lifetime warranty. Installation requires their universal mounting kit, part # DZDB-2502.
    view full answer...

  • Appearance of Curt Trailer Hitch, Part # C11111, After Installation on the 2011 Infiniti M37 Sport
  • I do not have a photo of a completed installation performed by etrailer with this particular hitch , Curt Trailer Hitch for the 2011 Infiniti M37, Part # C11111, on your specific vehicle. However. within the manufacturer installation instructions there is a representative photo showing this product installed. I have included a close-up image of this photo. It is worth noting that this hitch installation on your vehicle is fairly involved and the manufacturer rates the level of difficulty...
    view full answer...

  • Noise Level And Weight Of Magnaflow Exhaust System On 2007 G35 Coupe
  • I spoke with my contact at Magnaflow about your 2007 Infiniti G35 Coupe. They told me that the Stainless Steel Cat-Back Exhaust System, part # MF16641 is not much louder than the stock system it replaces. They told me that there is a small change in the pitch but an insignificant change in the noise level. This system is designed to increase horsepower and torque and is constructed of stainless steel. They also told me that this system weighs quite a lot less than the stock system installed...
    view full answer...

  • Location Of Brake Controller Connection Port On A 2012 Infiniti QX56
  • If you have the factory 7-way connector on your 2012 Infiniti QX56, the connector used for the brake controller will be located under the driver side of the dash. I have attached a photo that shows what the plug-in adapter on the harness that connects between the brake controller and the vehicle connector looks like. If the pins on the connector you found under the dash match the pin pattern of the connector in the photo then that is your connector. You may have to remove a small panel...
    view full answer...

  • How To Find Correct Bearing Buddy For Yacht Club Boat Trailer
  • You will want to get a measurement that is as accurate as you can when measuring for Bearing Buddies. You can use a digital caliper like part # PTW80157 to measure the inside of the hub opening the Bearing Buddy is used on. If you find the inside measurement of your hub is 1.98 inches, part # BB1980A-SS would work well for you. Another way to find out what will work is to let me know the outside bearing number on your trailer. It is usually found stamped on the outside of the bearing...
    view full answer...

  • Will Extension Be Needed to Install Hopkins Smart Hitch Back Up Camera # HM50002 on 2011 GMC Sierra
  • A regular cab short bed Sierra is about 17-1/2 feet long, and the cable included with the camera is 19-1/2 feet long. Your crew cab is a bit longer. I'd say you're right on the borderline of needing the extension. The easiest way to find our for sure if you need it would be to take a piece of string and run it from the back bumper at the trailer connector, under the car, into the engine compartment and through the firewall into the passenger cabin to where you're wanting the monitor to...
    view full answer...

  • Installing Brake Controller On 2004 Infiniti QX56
  • The brake controller I recommend for your 2004 QX56 is the Prodigy P3, part # 90195. This is one of our most popular because it is easy to install and operate. You will also need the plug-in wiring adapter, part # 3050-P. This plugs into the back of the brake controller and the other end plugs into the harness that can be found under the dash, to the left of the steering column, and will be taped to another harness near the emergency brake pedal.
    view full answer...

  • Do You Have Any Images of the Thule Motion XT # TH629506 with Bags and/or Luggage?
  • I have a great solution for you. Even though we do not have pictures of bags/luggage inside the Thule Motion XT # TH629506, we do have the interior dimension to give you the definite measurements that you would be working with. The interior dimensions if the Thule Motion XT 16 are 84-1/2" long x 33" wide x 11-1/4" tall. With these measurements, I recommend measuring the cargo you wish to transport to make sure it would fit. In order to mount this cargo box on your vehicle, you will need...
    view full answer...

  • Can the Rola Enclosed Cargo Carrier be Painted to Match a Vehicle Color
  • Paint would not stick well to the Rola enclosed cargo carrier. But if you can find the right kind of paint for the material (plastics) then you can certainly try. It may not last all that long and you will find yourself painting it again or touching it up.
    view full answer...

  • Appearance Of Trailer Hitch When Installed On 2013 Infiniti FX50S
  • The design of the trailer hitches we offer that will fit your FX50S have a visible crossbar. We offer two hitches for your vehicle. We have photos of the installation of the Curt Trailer Hitch, part # 13554 and as you can see in the attached photo, the crossbar is visible. This is a Class lll trailer hitch and it has a 2-inch receiver opening. It is a round-tube design which does make it more attractive in many folk's opinion. The second hitch we offer is designed in much the same manner...
    view full answer...

  • Is There a Photo of Hitch Receiver 76031 Installed on a 2013 Infiniti JX35
  • We are always adding new vehicles and parts to our library of photos and videos, but at present we do not have a photo of this hitch installed on a 2013 Infiniti JX35. I also checked with my contact at Draw-Tite to see if they might have a photo of this product installed on your JX35, but they do not. However I was able to obtain one measurement that might be useful to you. That measurement is the distance from the bottom of the vehicle frame rails (the main left and right frame members...
    view full answer...