This is a good question but the Redarc Tow Pro Elite # RED44FR does install with the part # 3027-P but you have to cut off the black connector and then wire the colors to the brake controller wiring color for color. We don't have a Redarc connector that matches so this is best option and still makes install much easier. view full answer...
Yes, the Roadmaster Spare Tire Carrier # RM-195125 can pivot to the left or right depending on what kind off clearance you have. We only show to the left in the video because there is a ladder on the right side, but if you check out the attached photo you'll see we have it tilted to the right in case you need access to the left side of your motorhome, like what seems to be your case. view full answer...
The reason a vehicle has to have the battery disconnected when being flat towed like with your Ford Focus is that the ignition has to be in a specific position for the steering wheel to unlock which turns on several circuits which would drain the battery of the tow vehicle if it was left on.
So the solution is to disconnect the battery so that you can unlock the steering wheel without draining it. That what's nice about the Roadmaster Automatic Battery Disconnect # RM-766 is that it does... view full answer...
With how the stock rack of the Winnebago Revel is you wouldn't be able to use the clamp-on installation methods for the Yakima SlimShady Awning # Y36VR or Thule HideAway Awning # TH490008. You would have to custom fabricate some brackets to either bolt through the rails of the rack or clamp to them. Both awning do have wall mount brackets that you could get separately to help mount to whatever you come up with for the rails (Yakima # Y84AR and Thule # TH308960). view full answer...
Yes, once installed the Firestone Ride-Rite Air Helper Springs # F2603 will reduce the strain on your rear suspension. The # F2603 helps prevent permanent sagging and excessive friction on leaf springs. It will also reduce tire wear and improve steering control. These air helper springs absorb road shock and soften contact between the frame and axle to prevent bottoming out.
I would also recommend adding an air compressor like the Firestone Air Command II # F2168. This is a dual path system... view full answer...
The correct SumoSprings Custom Helper Springs for your 2018 Winnebago Sunstar 31BE (that features an 18,000 pound GVWR), which is the part # SSF-170-40-2 for the front axle and # SSR-184-40-1 for the rear axle, will not require any drilling during installation. These are complete bolt-on applications that will simply replace the factory bump stops on the Ford F-53 chassis.
I have attached a couple short video demonstrations along with the written installation manuals for these kits that... view full answer...
The Firestone Ride-Rite Air Helper Springs item # F2603 you referenced will address any sagging issues you may be encountering that affects your ride height. It will not lift it in the sense that you are asking for. The most it will do is return your 3 year old suspension system to its factory ride height. Depending on how many miles and usage your current springs have this may give you the height increase you are looking for but a 2" lift is not the air helper springs designed purpose.... view full answer...
All you will need is the Solera 12V Power RV Awning Conversion Kit - Universal - 69" Arms - White # LC434724. No other parts need to be purchased to complete the conversion to powered awning. view full answer...
In regards to the Furrion Vision S Wireless RV Observation Camera System part # FCE48TASL-05, you shouldn't need to run any new power wires so long as you already have a similar system in place. The main overhead camera will simply just use the same power wire your existing system uses. If you did not have an existing power wire you could just run a wire up spliced into the running light or back-up circuit, but this does not pertain to you since you already have a system in place that you... view full answer...
We've checked with Lippert in the past and they have told us that the Kwikee Level Best control panel can be replaced with the Lippert Control Panel part # LC175225 but on older models like yours which was made in 2003 you do have to also install the new harness part # LC178278 as well which is the issue you are running into. view full answer...
Furrion states that there really is no minimum for things that are mounted on the same wall. You wouldn't want the fireplace blowing directly on anything combustible. The fireplace has a proximity sensor that will shut it down if an object is placed within 6 inches in front of the fireplace, it'll shut down until the object is removed and the power switch is cycled.
Other than that, there are no further limitations. If you click the provided link, you can see a product description video... view full answer...
Yes, the Alpha Systems Alphabond Repair Tape for RV Roofs # AL32KV will adhere to a fiberglass roof. You will want to make sure the area you are adhering too is thoroughly cleaned. We do not have a recommended adhesive, you will just want to be sure you use an adhesive that is intended to be used with fiberglass.
You will then want to use a non-sag sealant like the LaSalle Bristol XTRM Universal Non-Sag Sealant for RVs # 344270341437-1 to make sure you seal everything completely. This... view full answer...
Yes, the Roadmaster Exact Center Steering Stabilizer with Custom Brackets for Ford F-53 Chassis, # RM36RR will have a installation instructions included.
I also highly recommend the Roadmaster Anti-Sway Bars, # RM-1139-146 for the rear and, # RM-1139-148 for the front to minimize side-to-side movement and improve overall stability of your vehicle. view full answer...
The Dexter DX7.5 Drop-N-Go Brake Actuator # 099-175-20 should be wired to the reverse light circuit on your 7-way. Although I do not have a specific wiring diagram, this is a simple process. There are two wires on your brake actuator. One will be the ground and the other connects to the reverse lights. These are interchangeable so you don't have to worry which you use.
The reverse lights should run to the middle pin on your 7-way connector. The wire color is typically going to be yellow... view full answer...
Currently we have no way to verify if the Lippert SolidStep RV Steps for 29" to 36" Wide Doorways - 3 Steps # LC791573 will fit the 2014 Winnebago One 30RE. I have linked our help article near the bottom of the page which will take you through the necessary steps to verify if you will be able to add steps to this camper. view full answer...
The SumoSprings Solo Custom Helper Springs # SSF-106-47 is sold as a pair and will cover both sides of the front of the vehicle. If this is for just one vehicle, you will only need to order one set. view full answer...
Yes you could use the Solera 12V Power RV Awning Conversion Kit part # LC434724 to convert your A and E two step awning to a powered electric awning. view full answer...
Nice question, lets find out below:
First we need to make sure that you have the right fit.
Measure from the ground up to the door frame and then measure the width.
**TorkLift GlowStep Stow N' Go Scissor Steps w/ Landing Gear - 3 Steps - 375 lbs - Black Bracket # TLA7833.
This unit listed above fits entry heights 23-1/2 to 34-1/4 inches tall.
The mounting bracket needs an area right under the entry door that is 21-1/2" wide x 12-1/2" tall x 8-1/2.
Here is a list of the basic mounting... view full answer...
Those four items are used to help secure the trays when they are in the up position and not carrying bikes. They are the perfect size to fit around the tubes of this bike rack. view full answer...